Oxidation rates of a single char particle in an electrodynamic balance
โ Scribed by M. D'Amore; L. Tognotti; A.F. Sarofim
- Publisher
- Elsevier Science
- Year
- 1993
- Tongue
- English
- Weight
- 608 KB
- Volume
- 95
- Category
- Article
- ISSN
- 0010-2180
No coin nor oath required. For personal study only.
โฆ Synopsis
The changes in reaction rate of a carbon char with conversion in the temperature range 500-1200 K are followed by using an electrodynamic balance (EDB). This device allows, in a temperature range wider than in other apparatus, in situ measurements of mass, diameter, density, surface area, rate of reaction, and temperature for a single, suspended submillimeter particle as the reaction takes place. A synthetic char (Spherocarb) has been used because of its low ash and volatile matter contents and its spherical shape. The results on oxidation kinetics obtained in an EDB are compared with low-temperature reaction rate data, obtained by conventional thermogravimetric apparatus on Spherocarb, and with the data obtained in an entrained-flow reactor at temperatures typical of pulverized-fuels combustors. The correlation between all the data in the temperature range 500-2300 K is examined. EDB data can be combined with entrained-flow data to depict a sharp change in reaction regime from a chemical kinetic to an internal diffusion control. A simple Thiele analysis, considering different classes of pores, yields results that suggest pores in the 100-1000 nm range are responsible for diffusional constraints that cause the kinetic data to depart from the chemical regime.
๐ SIMILAR VOLUMES
The rate of burning of wooden dowels injected into the centre of various test fires was determined by direct weighing. The curves giving the rate of burning vs. time of exposure are presented for dowels of length 88.9 mm and diameters ranging from 2.54 mm to 50.8 ram. Five types of wood: birch, oak,
this paper on approximation is described making it possible to calculate temporal temperature and adsorbed amount profiles during an adsorption process in a single pellet. The suggested model includes heat transfer in an external film and mass transfer inside a porous structure. The profiles calcula