The interaction forces between silica and plasma-treated polypropylene surfaces in aqueous NaCl solutions have been measured using a scanning force microscope. The measured interaction forces are well described by DLVO theory at large and moderate separation distances. However, at short range (<5 nm
Origins of the Non-DLVO Force between Glass Surfaces in Aqueous Solution
✍ Scribed by Joshua J. Adler; Yakov I. Rabinovich; Brij M. Moudgil
- Publisher
- Elsevier Science
- Year
- 2001
- Tongue
- English
- Weight
- 153 KB
- Volume
- 237
- Category
- Article
- ISSN
- 0021-9797
No coin nor oath required. For personal study only.
✦ Synopsis
Direct measurement of surface forces has revealed that silica surfaces seem to have a short-range repulsion that is not accounted for in classical DLVO theory. The two leading hypotheses for the origin of the non-DLVO force are (i) structuring of water at the silica interface or (ii) water penetration into the surface resulting in a gel layer. In this article, the interaction of silica surfaces will be reviewed from the perspective of the non-DLVO force origin. In an attempt to more accurately describe the behavior of silica and glass surfaces, alternative models of how surfaces with gel layers should interact are proposed. It is suggested that a lessened van der Waals attraction originating from a thin gel layer may explain both the additional stability and the coagulation behavior of silica. It is important to understand the mechanisms underlying the existence of the non-DLVO force which is likely to have a major influence on the adsorption of polymers and surfactants used to modify the silica surface for practical applications in the ceramic, mineral, and microelectronic industries.
📜 SIMILAR VOLUMES
In this paper, the streaming potential technique is utilized to measure the ζ -potential of glass surface in contact with a variety of aqueous solutions. A flow cell made of a parallel-plate microchannel is devised to conduct the streaming potential measurements. Particular efforts are made to chara
## Abstract __The surface processes involved in the initial stages of the proton‐assisted dissolution of the calcite single crystal cleavage plane (10__$\bar 1$__4) have been identified using a combined scanning electrochemical–atomic force microscope (SECM‐AFM). This instrument employs a platinum‐