✦ LIBER ✦

Optimizing the QoS of high speed moving terminals in cellular networks

✍ Scribed by K. Ioannou; S. Kotsopoulos; P. Stavroulakis

Publisher: John Wiley and Sons
Year: 2003
Tongue: English
Weight: 224 KB
Volume: 16
Category: Article
ISSN: 1074-5351
DOI: 10.1002/dac.621

No coin nor oath required. For personal study only.

✦ Synopsis

Abstract

This paper presents a dynamic guard channel assignment technique based on a two‐layer cellular architecture which optimizes the blocking probability performance of high‐speed moving terminals (HSMT) and handoff calls of low‐speed moving terminals (LSMT), in a congested urban area. The lower layer of the proposed architecture is based on a microcellular solution, for absorbing the traffic loads of LSMT. The higher layer is based on a macro‐cell umbrella solution, for absorbing the traffic load of the HSMT. The results show that using the optimum number of channels and adjusting dynamically the number of guard channels in each layer, the blocking probability of the HSMT and the handoff blocking probability of LSMT is optimized having the minimum bad effect on the new call blocking probability of LSMT. Copyright © 2003 John Wiley & Sons, Ltd.

📜 SIMILAR VOLUMES

GROUND VIBRATION IN THE VICINITY OF A HI

GROUND VIBRATION IN THE VICINITY OF A HIGH-SPEED MOVING HARMONIC STRIP LOAD

✍ G. LEFEUVE-MESGOUEZ; D. LE HOUÉDEC; A.T. PEPLOW 📂 Article 📅 2000 🏛 Elsevier Science 🌐 English ⚖ 246 KB

The transmission of vibrations over the surface of the ground, due to a high-speed moving, vertical harmonic strip load, is investigated theoretically. Consequently, the problem is essentially two-dimensional and the interior of the ground is modelled as an elastic half-space. The transformed soluti

Optimal digital computer control of casc

Optimal digital computer control of cascaded vehicles in high-speed transportation systems in the presence of measurement noise and stochastic input disturbances

📂 Article 📅 1970 🏛 Elsevier Science ⚖ 73 KB

Grey relational analysis coupled with pr

Grey relational analysis coupled with principal component analysis for optimization design of the cutting parameters in high-speed end milling

✍ H.S. Lu; C.K. Chang; N.C. Hwang; C.T. Chung 📂 Article 📅 2009 🏛 Elsevier Science 🌐 English ⚖ 237 KB

This paper investigates optimization design of the cutting parameters for rough cutting processes in high-speed end milling on SKD61 tool steel. The major characteristics indexes for performance selected to evaluate the processes are tool life and metal removal rate, and the corresponding cutting pa