𝔖 Bobbio Scriptorium
✦   LIBER   ✦

Optimal drilling of particulate metal matrix composites based on experimental and numerical procedures

✍ Scribed by J.Paulo Davim; C.A Conceição António

Publisher
Elsevier Science
Year
2001
Tongue
English
Weight
242 KB
Volume
41
Category
Article
ISSN
0890-6955

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Some experimental data on workability of
Some experimental data on workability of aluminium-particulate-reinforced metal matrix composites
✍ Mohamed A. Taha; Nahed A. El-Mahallawy; Ahmed M. El-Sabbagh 📂 Article 📅 2008 🏛 Elsevier Science 🌐 English ⚖ 975 KB

The workability of aluminium-SiC and Al 2 O 3 -reinforced metal matrix composites (APMMCs) prepared by stir-casting, squeeze-casting and powder metallurgy techniques has been studied by using up-set test. Different parameters of APMMC were considered such as type of Al matrix alloy, type of particul

Some studies on drilling of hybrid metal
Some studies on drilling of hybrid metal matrix composites based on Taguchi techniques
✍ S. Basavarajappa; G. Chandramohan; J. Paulo Davim 📂 Article 📅 2008 🏛 Elsevier Science 🌐 English ⚖ 372 KB

Drilling is a metal removal process and is important for the final fabrication stage prior to application. This paper discusses the influence of cutting parameters on drilling characteristics of hybrid metal matrix composites (MMCs)-Al2219/15SiCp and Al2219/15SiCp-3Gr. The composites are fabricated

Optimization of testing parameters on th
Optimization of testing parameters on the wear behaviour of metal matrix composites based on the Taguchi method
✍ Y. Sahin 📂 Article 📅 2005 🏛 Elsevier Science 🌐 English ⚖ 303 KB

The weight loss model of aluminium alloy composites with 10 wt.% SiC particles by molten metal mixing method was developed in terms of abrasive grain size, reinforcement size used in the composite, applied load and sliding distance using the Taguchi method. The two-body abrasive wear behaviour of th