Two experimental methods are usually employed to study liquid penetration in porous media. One of them is based on the measure of the height of the advance liquid front vs time, and the other one is based on the measure of the weight gained by the porous system due to the liquid penetration vs time.
On the Use of Washburn's Equation in the Analysis of Weight–Time Measurements Obtained from Imbibition Experiments
✍ Scribed by L Labajos-Broncano; M.L González-Martı́n; J.M Bruque; C.M González-Garcı́a; B Jańczuk
- Publisher
- Elsevier Science
- Year
- 1999
- Tongue
- English
- Weight
- 92 KB
- Volume
- 219
- Category
- Article
- ISSN
- 0021-9797
No coin nor oath required. For personal study only.
✦ Synopsis
A careful analysis of the experimental results from imbibition experiments, expressed as the increased weight of a porous layer once it was in contact with a liquid, vs time, has been done on the basis of Washburn's equation, which is usually the main tool for that analysis. It has been found that the experimental results reflect other physical phenomena more than imbibition, among them the effect of the initial contact between plate and liquid and the evaporation of liquid from the wetted porous layer. The unavoidable disturbance introduced by the first of these phenomena leads to the need for rescaling of the experimental data. Once this is done, Washburn's equation has to be applied accordingly to the new reference system chosen. Also, it has been shown that if evaporation is present, experimental data deviate from Washburn's predictions. This effect disappears if the porous layer is covered.
📜 SIMILAR VOLUMES
given by Coleman, Markovitz, and No11 ( 3 ) . Oldroyd ( 4 ) obtained essentially the same results for S for the steady flow case by a different method. For the particular flow studied by Johns,
A procedure is described for computing sedimentation coefficient distributions from the time derivative of the sedimentation velocity concentration profile. Use of the time derivative, (delta c/delta t)r, instead of the radial derivative, (delta c/delta r)t, is desirable because it is independent of