𝔖 Bobbio Scriptorium
✦   LIBER   ✦

On the thermal degradation of poly(vinyl chloride). IV. Initiation sites of dehydrochlorination

✍ Scribed by K. B. Abbås; E. M. Sörvik


Publisher
John Wiley and Sons
Year
1976
Tongue
English
Weight
613 KB
Volume
20
Category
Article
ISSN
0021-8995

No coin nor oath required. For personal study only.

✦ Synopsis


Abstract

A set of poly(vinyl chloride) samples were investigated with respect to their thermal stability. The dehydrochlorination rates were measured in nitrogen at 190°C by use of a very accurate, conductometric method. For all polymers studied, a significant molecular weight increase was observed after 0.4% conversion. With only one exception, samples exhibiting higher degradation rates showed higher absorptions (350–450 nm) after 0.4% dehydrochlorination. In addition, the relative amount of short polyene sequences was found to be higher for polymers with higher degrees of branching. The dehydrochlorination reaction was predominantly initiated at sites of internal unsaturation (allylic chlorines), but an initiation at tertiary chlorines and unstable end‐groups could not be completely omitted. Head‐to‐head units, extraneous impurities, and syndiotactic sequences were found to be of minor importance in this respect.


📜 SIMILAR VOLUMES


Investigations on thermal dehydrochlorin
✍ A. Crosato-Arnaldi; G. Palma; E. Peggion; G. Talamini 📂 Article 📅 1964 🏛 John Wiley and Sons 🌐 English ⚖ 388 KB 👁 2 views

The thermal dehydrochlorination of PVC has been examined on some samples prepared by fractionation of a commercial PVC, and some other samples obtained by polymerization at different temperatures. The results disagree with the concept of a continuous dehydrochlorination from one side to the other of

Thermal dehydrochlorination of poly(viny
✍ Yoshihiko Uegaki; Tsutomu Nakagawa 📂 Article 📅 1977 🏛 John Wiley and Sons 🌐 English ⚖ 443 KB 👁 2 views

The thermal degradation of poly(viny1 chloride) (PVC) was studied by following the rates of dehydrochlorination a t temperatures between 18OOC and 280°C in pure nitrogen and air flow. Iron oxide accelerates the elimination of hydrogen chloride from PVC. The accelerating effect depends on the concent

Thermal degradation of poly(vinyl chlori
✍ H. İsmet Gökçel; Devrim Balköse 📂 Article 📅 1998 🏛 John Wiley and Sons 🌐 English ⚖ 245 KB 👁 3 views

An emulsion, poly(vinyl chloride) (PVC), was analyzed for its components and was used in the preparation of flexible PVC plates utilizing sol-gel processing technology. PVC contained an ether-soluble fraction having carboxylic acid carbonyl groups, a tetrahydrofurane (THF)-insoluble fraction having

Radiation effects on the thermal degrada
✍ Wenwei Zhao; Yukio Yamamoto; Seiichi Tagawa 📂 Article 📅 1998 🏛 John Wiley and Sons 🌐 English ⚖ 199 KB 👁 3 views

Radiation effects on the formation of conjugated double bonds in the thermal degradation of poly(vinyl chloride) (PVC) and poly(vinyl alcohol) (PVA) were investigated. Thin films of PVC and PVA were either irradiated with ␥-rays at ambient temperature (pre-irradiation) and then subjected to thermal

Studies in the thermal degradation of po
✍ Felix E. Okieimen; Justus E. Ebhoaye 📂 Article 📅 1993 🏛 John Wiley and Sons 🌐 English ⚖ 332 KB 👁 3 views

Thermal degradation of poly (vinyl chloride ) (PVC ) was studied in nitrogen atmosphere in the presence of rubber seed oil and epoxidized rubber seed oil, barium and lead soaps of rubber seed oil, and epoxidized seed oil at various temperatures. The rate of dehydrochlorination at 1% degradation and