✦ LIBER ✦

On the problem of determining drop size distribution in stirred liquid-liquid systems

✍ Scribed by A.J. Madden; B.J. McCoy

Publisher: Elsevier Science
Year: 1964
Tongue: English
Weight: 305 KB
Volume: 19
Category: Article
ISSN: 0009-2509
DOI: 10.1016/0009-2509(64)85077-6

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Drop size distribution of stirred non-co

Drop size distribution of stirred non-coalescing liquid—liquid system

✍ D.E. Brown; K. Pitt 📂 Article 📅 1972 🏛 Elsevier Science 🌐 English ⚖ 525 KB

Drop size in stirred liquid—liquid syste

Drop size in stirred liquid—liquid systems via encapsulation

✍ B.J. McCoy; A.J. Madden 📂 Article 📅 1969 🏛 Elsevier Science 🌐 English ⚖ 440 KB

Shorter Communications = 28\*12(V,)Ai -cms/sec when Pa is expressed in ems. (3) Consider now fluidised particles of average diameter 80 p and assume that the minimum bubble size the bed could sustain is 050 cm dia. From (3) above the flow rate to produce these minimum sized bubbles is 2.9 cmYsec. T

Drop size distribution in agitated liqui

Drop size distribution in agitated liquid-liquid systems

✍ Hsiao Tsung Chen; Stanley Middleman 📂 Article 📅 1967 🏛 American Institute of Chemical Engineers 🌐 English ⚖ 698 KB

Experiments, Modeling and Simulation of

Experiments, Modeling and Simulation of Drop Size Distributions in Stirred Liquid/ Liquid Systems

✍ A. Gäbler; M. Kraume; A. Paschedag; S. Schlauch; V. Mehrmann 📂 Article 📅 2005 🏛 John Wiley and Sons 🌐 German ⚖ 139 KB 👁 2 views

Influence of Physical Properties on Drop

Influence of Physical Properties on Drop Size Distribution of Stirred Liquid-Liquid Dispersions

✍ M. Kraume; A. Gäbler; K. Schulze 📂 Article 📅 2004 🏛 John Wiley and Sons 🌐 English ⚖ 241 KB 👁 2 views

Drop size distributions in strongly coal

Drop size distributions in strongly coalescing agitated liquid-liquid systems

✍ F. B. Sprow 📂 Article 📅 1967 🏛 American Institute of Chemical Engineers 🌐 English ⚖ 395 KB 👁 3 views

## Emulsion drop size distributions have been measured at various locations in a turbine mixer for the methyl isobutyl ketone-salt water system. The drop sizes are strongly dependent on the sampling position, being smallest near the impeller tip and largest at the bottom of the mixing tank. The va