✦ LIBER ✦

On the Bott-Duffin Synthesis of Driving-Point Impedances

✍ Scribed by Belevitch, V.

Book ID: 114614496
Publisher: Institute of Electrical and Electronics Engineers
Year: 1954
Tongue: English
Weight: 133 KB
Volume: CT-1
Category: Article
ISSN: 0197-6389
DOI: 10.1109/tct.1954.1083582

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Comments on "Active RC Single-Opamp Desi

Comments on "Active RC Single-Opamp Design of Driving-Point Impedances

✍ Abdallah, Y. 📂 Article 📅 1981 🏛 IEEE ⚖ 123 KB

A note on a theorem on the summation of

A note on a theorem on the summation of driving-point and transfer network impedances

✍ Hajj, I.N. 📂 Article 📅 1984 🏛 IEEE 🌐 English ⚖ 196 KB

Authors' Reply to Comments on 'Active RC

Authors' Reply to Comments on 'Active RC Single-Opamp Design of Driving-Point Impedances'

✍ Moschytz, G.; Horn, P. 📂 Article 📅 1981 🏛 IEEE ⚖ 186 KB

On the Total Amount of Inductance and Ca

On the Total Amount of Inductance and Capacitance Needed in the Bott-Duffin Realization and its Modifications

✍ Bar-Lev, A. 📂 Article 📅 1962 🏛 Institute of Electrical and Electronics Engineers 🌐 English ⚖ 235 KB

Driving-point mechanical impedance of th

Driving-point mechanical impedance of the human hand-arm system: synthesis and model development

✍ R. Gurram; S. Rakheja; A.J. Brammer 📂 Article 📅 1995 🏛 Elsevier Science 🌐 English ⚖ 834 KB

A synthesis of the measured values of human male hand-arm impedance characteristics reported in the literature has been performed. The driving-point mechanical impedance data of the human hand-arm grasping a vibrating handle has been compared to highlight the various similarities and differences amo

The driving-point impedance of a plate w

The driving-point impedance of a plate with an attached subsystem

✍ Z.C. Zhang; B.L. Clarkson 📂 Article 📅 1984 🏛 Elsevier Science 🌐 English ⚖ 634 KB

A general expression for the driving-point impedance of an infinite thin plate with an attached subsystem some distance from the driving point is derived. The analysis is based upon the receptance method and the reciprocal theorem. As an example, an infinite plate with an attached rigid circular cyl