## Abstract In this paper, resonant frequency and quality factors of a square‐corner‐cut dielectric resonator are obtained by using the finite‐difference time‐domain (FDTD) method, and the resonant frequencies of some modes in the resonator are analyzed. Some useful results are obtained. © 2002 Wil
On a quality factor of whispering gallery mode dielectric resonators in a form of cone
✍ Scribed by Nickolay T. Cherpak; Sergey A. Bunyaev; Alexander A. Barannik
- Publisher
- John Wiley and Sons
- Year
- 2007
- Tongue
- English
- Weight
- 156 KB
- Volume
- 49
- Category
- Article
- ISSN
- 0895-2477
No coin nor oath required. For personal study only.
✦ Synopsis
Abstract
The whispering gallery mode (WGM) resonators in a form of cone demonstrate that a quality factor Q in microwave range decreases monotonously with increase of angle α between a cone axis and generatrix. Both a form of the resonator made of Teflon and coupling between the resonator and input/output dielectric waveguides are analogous to them in the optic microcavity, where it was supposed that isolating mode from the disk perimeter resulted in Q increase. However the effect of increase of Q with α is not observed in microwave range. The cone resonators excited on WGM promise to become useful for microwave and millimeter‐wave characterization of high‐T~c~ superconducting films. © 2007 Wiley Periodicals, Inc. Microwave Opt Technol Lett 49: 1987–1989, 2007; Published online in Wiley InterScience (www.interscience.wiley.com). DOI 10.1002/mop.22625
📜 SIMILAR VOLUMES
A rigorous mode-matching technique is implemented for the study of the unloaded Q-factor of a dielectric resonator operating in the TM -mode. Numerical results demonstrate the ¨ariation of the 01␦ unloaded Q-factor against geometrical and material parameters. Finally, the accuracy of the calculation