๐”– Bobbio Scriptorium
โœฆ   LIBER   โœฆ

Numerical and experimental investigations on heat/mass transfer of slot-jet impingement in a rectangular cavity

โœ Scribed by P.W. Li; W.Q. Tao


Publisher
Elsevier Science
Year
1993
Tongue
English
Weight
735 KB
Volume
14
Category
Article
ISSN
0142-727X

No coin nor oath required. For personal study only.


๐Ÿ“œ SIMILAR VOLUMES


Nonlinear flow and heat transfer dynamic
โœ Haydar Eren; Nevin Celik; Bulent Yesilata ๐Ÿ“‚ Article ๐Ÿ“… 2006 ๐Ÿ› Elsevier Science ๐ŸŒ English โš– 278 KB

The nonlinear flow and heat transfer characteristics for a slot jet impinging on a slightly curved concave surface are experimentally studied here. The effects of jet Reynolds number on the jet velocity distribution and circumferential Nusselt numbers are examined. The nozzle geometry is a rectangul

Analytical and experimental investigatio
โœ Kyu Hyung Do; Tae Hoon Kim; Sung Jin Kim ๐Ÿ“‚ Article ๐Ÿ“… 2010 ๐Ÿ› Elsevier Science ๐ŸŒ English โš– 434 KB

In this paper, modified similarity solutions for velocity and temperature distributions in the heat sink subject to a uniformly impinging jet are presented. A heat sink is modeled as a fluid-saturated porous medium and a similarity transformation is employed. The Brinkman-extended Darcy equations fo

Numerical and experimental investigation
โœ Tao Lu; Shengqiang Shen; Xiaohua Liu ๐Ÿ“‚ Article ๐Ÿ“… 2008 ๐Ÿ› John Wiley and Sons ๐ŸŒ English โš– 846 KB

## Abstract The heat and mass transfer in an unsaturated wet cylindrical bed packed with quartz particles was investigated theoretically and experimentally for relatively low convective drying rates. The medium was dried by blowing dry air over the top of the porous bed which was insulated by imper

Experimental investigation of forced and
โœ Irfan Kurtbas; Nevin Celik ๐Ÿ“‚ Article ๐Ÿ“… 2009 ๐Ÿ› Elsevier Science ๐ŸŒ English โš– 493 KB

An experimental study was performed to investigate the heat transfer characteristics of the mixed convection flow through a horizontal rectangular channel where open-cell metal foams of different pore densities (10, 20 and 30 PPI) were situated. A uniform heat flux was applied at all of the bounding