Nucleation of microcellular foam: Theory and practice

✍ Scribed by Jonathan S. Colton; Nam P. Suh

• Book ID: 104520937
• Publisher: Society for Plastic Engineers
• Year: 1987
• Tongue: English
• Weight: 423 KB
• Volume: 27
• Category: Article
• ISSN: 0032-3888
• DOI: 10.1002/pen.760270704

✦ Synopsis

Microcellular polymer foams exhibit greatly improved mechanical properties as compared to standard foams due to the formers' small bubble size. Microcellular foams have bubbles with diameters on the order of 10 microns, volume reductions of 30 to 40 percent, and six or seven times the impact strength of solid parts. They are produced through the use of thermodynamic instabilities without the use of foaming agents. This method leads to a very uniform cell size throughout a part's cross section. A theoretical model for the nucleation of microcellular foams in thermoplastic polymers has been developed and experimentally confirmed. This model explains the effect.of various additives and processing conditions on the number of bubbles nucleated. At levels of secondary constituents below their solubility limits, an increase in the concentration of the additive or the concentration of gas in solution with the polymer increases the number of bubbles nucleated. Nucleation in this region is homogeneous. Above the solubility limit of additives, nucleation is heterogeneous and takes place at the interface between second phase inclusions and the polymer. The number of bubbles nucleated is dependent on the concentration of heterogeneous nucleation sites and their relative effect on the activation energy barrier to nucleation. In the vicinity of the solubility limit, the two mechanisms compete.