✦ LIBER ✦

Non-isothermal process rheology of thermoplastic composites for compression flow moulding

✍ Scribed by R Törnqvist; P Sunderland; J.A.E Månson

Book ID: 117758123
Publisher: Elsevier Science
Year: 2000
Tongue: English
Weight: 682 KB
Volume: 31
Category: Article
ISSN: 1359-835X
DOI: 10.1016/s1359-835x(00)00048-8

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Non-isothermal ‘2-D flow/3-D thermal’ de

Non-isothermal ‘2-D flow/3-D thermal’ developments encompassing process modelling of composites: flow/thermal/cure formulations and validations

✍ Nam D. Ngo; Kumar K. Tamma 📂 Article 📅 2001 🏛 John Wiley and Sons 🌐 English ⚖ 282 KB

Non-isothermal, compressible gas flow fo

Non-isothermal, compressible gas flow for the simulation of an enhanced gas recovery application

✍ N. Böttcher; A.-K. Singh; O. Kolditz; R. Liedl 📂 Article 📅 2012 🏛 Elsevier Science 🌐 English ⚖ 810 KB

Experimental investigation and flow visu

Experimental investigation and flow visualisation of the resin transfer mould filling process for non-woven hemp reinforced phenolic composites

✍ M.O.W Richardson; Z.Y Zhang 📂 Article 📅 2000 🏛 Elsevier Science 🌐 English ⚖ 559 KB

A minimal composite theory for stability

A minimal composite theory for stability of non-parallel compressible boundary-layer flow

✍ K. Sanjeev Rao; Rajeswari Seshadri; Rama Govindarajan 📂 Article 📅 2004 🏛 Springer 🌐 English ⚖ 266 KB

A fixed mesh numerical method for modell

A fixed mesh numerical method for modelling the flow in liquid composites moulding processes using a volume of fluid technique

✍ J.A. Garcı́a; Ll. Gascón; F. Chinesta 📂 Article 📅 2003 🏛 Elsevier Science 🌐 English ⚖ 455 KB

This paper presents the development and application of a numerical procedure for the simulation of the flow phenomena involved in composite manufacturing processes. The kinematic resolution combines a discretization of the volume fraction evolution equation and the verification of the movement and t

Process chain development for the rapid

Process chain development for the rapid prototyping of microstructured polymer, ceramic and metal parts: composite flow behaviour optimisation, replication via reaction moulding and thermal postprocessing

✍ Thomas Hanemann; Kirsten Honnef; Juergen Hausselt 📂 Article 📅 2007 🏛 Springer 🌐 English ⚖ 454 KB