Preparation of broad bean (Viciafaba L. minor) products Part. I. Broad bean protein isolates from seed flour and their acetylation in the neutral pH range CH. SCHNEIDEII. M . SCIIIILTZ and H. SCHMANDKE I t is possible to prepare broad bean protein isolates with a high yield directly from seed flour
Nitrogen extractability of sesame (Sesamum indicum L.) seed and the preparation of two protein isolates
✍ Scribed by Nilo Rivas R.; Jane E. Dench; John C. Caygill
- Publisher
- John Wiley and Sons
- Year
- 1981
- Tongue
- English
- Weight
- 469 KB
- Volume
- 32
- Category
- Article
- ISSN
- 0022-5142
No coin nor oath required. For personal study only.
✦ Synopsis
Abstract
Nitrogen extractability from sesame flour in water is greatest using a flour: solvent ratio of 1:40 and an extraction time of 15 min. At pH 4.0‐6.5, <10% nitrogen is extracted, whilst >90% is extracted at pH 11.0. In the presence of NaCl (0.5‐1.0M) nitrogen extractability is greatest at pH values > pH 4.0. The two sesame protein isolates produced were bland‐tasting, light‐coloured and contained approximately 95% protein. The alkali isolate (extracted in water at pH 10.0 and precipitated at pH 4.0) was readily solubilised and showed a good protein recovery (60%). The salt isolate (extracted in 1M NaCl at pH 6.0 and precipitated at pH 4.0) was less soluble and showed a lower protein recovery (50%). The sesame products were extracted sequentially using various solvents. Sesame flour proteins were mainly salt‐soluble (67%), alkali isolate proteins mainly water‐soluble (41%) and alkali‐soluble (41%), and salt isolate proteins mainly alkali‐soluble (35%). The amino acid composition of the sesame products is described. Oil‐expelled cake showed poor nitrogen extractability (53% at pH 11.0 in water) and was, therefore, a poor source for protein isolate production.
📜 SIMILAR VOLUMES
Broad bean protein isolates in aqueous solutions form stable gels after heating at pH values below the isoelectric point (pH 2 L 3 ) if they are extracted at the same pH. But the acid extraction is a time-consuming and expensive process. This paper outlines a new and simple procedure for the prepara