✦ LIBER ✦

NC Rough Machining of Sculptured Surface Based on Measured Data

✍ Scribed by Xue-yi LI; Hong JIANG; Xiao-chun WANG

Book ID: 114335363
Publisher: Elsevier Science
Year: 2004
Tongue: English
Weight: 193 KB
Volume: 17
Category: Article
ISSN: 1000-9361
DOI: 10.1016/s1000-9361(11)60204-5

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

The uniformity of remaining volume on ro

The uniformity of remaining volume on rough-machined sculptured surface parts

✍ A. Krimpenis; G.-C. Vosniakos 📂 Article 📅 2008 🏛 Springer 🌐 English ⚖ 378 KB

Research on the localisation of the work

Research on the localisation of the workpieces with large sculptured surfaces in NC machining

✍ Y. Sijie; Z. Yunfei; P. Fangyu; L. Xide 📂 Article 📅 2004 🏛 Springer 🌐 English ⚖ 406 KB

Measuring the roughness of a machined su

Measuring the roughness of a machined surface directly on the machine

✍ G. B. Bagdasaryan; R. G. Saakyan; R. A. Parsadanyan 📂 Article 📅 1978 🏛 Springer US 🌐 English ⚖ 193 KB

Rough and finish tool-path generation fo

Rough and finish tool-path generation for NC machining of freeform surfaces based on a multiresolution method

✍ Z. Yin 📂 Article 📅 2004 🏛 Elsevier Science 🌐 English ⚖ 283 KB

Progressive fitting and multiresolution tool path generating techniques are proposed in this paper, by which multi-level (LOD) models fitting for different subsets of sampled points are obtained, and then multiresolution rough-cut and finish-cut tool paths are generated based on the LOD models. The

Measurement of surface roughness on roug

Measurement of surface roughness on rough machined surfaces using spectral speckle correlation and image analysis

✍ Ulf Persson 📂 Article 📅 1993 🏛 Elsevier Science 🌐 English ⚖ 586 KB

An evaluation of surface roughness param

An evaluation of surface roughness parameters measurement using vision-based data

✍ Ghassan A. Al-Kindi; Bijan Shirinzadeh 📂 Article 📅 2007 🏛 Elsevier Science 🌐 English ⚖ 338 KB