๐”– Bobbio Scriptorium
โœฆ   LIBER   โœฆ

Multiple orientation technique for the calibration of cylindrical workpieces on CMMs

โœ Scribed by Sonko Osawa; Konrad Busch; Matthias Franke; Heinrich Schwenke

Book ID
108252148
Publisher
Elsevier Science
Year
2005
Tongue
English
Weight
593 KB
Volume
29
Category
Article
ISSN
0141-6359

No coin nor oath required. For personal study only.

๐Ÿ“œ SIMILAR VOLUMES

On the calibration of the electrical pot
On the calibration of the electrical potential technique for monitoring crack growth using finite element methods
โœ R. O. Ritchie; K. J. Bathe ๐Ÿ“‚ Article ๐Ÿ“… 1979 ๐Ÿ› Springer Netherlands ๐ŸŒ English โš– 443 KB

Finite element analysis procedures are utilized to provide theoretical calibration curves for the electrical potential crack-monitoring system as applied to single-edge-notch (SEN) and compact tension (CT) fracture specimens. The results are compared to existing calibrations for such test piece geom

A calibration technique for multiple-sen
A calibration technique for multiple-sensor hot-wire probes and its application to vorticity measurements in the wake of a circular cylinder
โœ B. Marasli; P. Nguyen; J. M. Wallace ๐Ÿ“‚ Article ๐Ÿ“… 1993 ๐Ÿ› Springer ๐ŸŒ English โš– 764 KB

A calibration technique for multiple-sensor hot-wire probes is presented. The technique, which requires minimal information about the probe geometry, is tested using a four-sensor and a twelve-sensor probe. Two data reduction algorithms are introduced. The first one assumes a uniform velocity over t