𝔖 Bobbio Scriptorium

✦ LIBER ✦

Mould filling simulation in powders injection moulding: L.A. Najimi, D. Lee (Rennselaer Polytechnic Inst., Troy, New York, USA), Int J Powder Metallurgy, Vol 30, No 1, 1994, 231–240.

Book ID: 116033442
Publisher: Elsevier Science
Year: 1994
Tongue: English
Weight: 137 KB
Volume: 49
Category: Article
ISSN: 0026-0657
DOI: 10.1016/0026-0657(94)90343-3

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Temperature effects during cooling in po

Temperature effects during cooling in powder injection moulding: R.T. Fox, D. Lee (Rennselaer Polytechnic Inst., Troy, New York, USA), Int J Powder Metallurgy, Vol 30, No 2, 1994, 221–229.

📂 Article 📅 1994 🏛 Elsevier Science 🌐 English ⚖ 137 KB

Behaviour of a powder/binder system — mo

Behaviour of a powder/binder system — moulding and thermal debinding: J.C. Moller, D. Lee (Rennselaer Polytechnic Inst., Troy, New York, USA), Int J Powder Metallurgy, Vol 30, No 1, 1994, 103–114.

📂 Article 📅 1994 🏛 Elsevier Science 🌐 English ⚖ 137 KB

Jetting phenomenon in powder injection m

Jetting phenomenon in powder injection moulding (PIM) : N. Piccirillo, D. Lee. (Rensselaer Polytechnic Institute, Troy, New York, USA.) Int. J. Powder Metallurgy, Vol 28, No 1, 1992, 13–25

📂 Article 📅 1992 🏛 Elsevier Science 🌐 English ⚖ 335 KB

A lumped parameter analysis of powder in

A lumped parameter analysis of powder injection moulding: M.F. Aksit, D.Lee (Rensselear Polytechnic Inst., Troy, New York, USA). Int. J. Powder Metall., vol 31, no 4, 1995, 351–361

📂 Article 📅 1996 🏛 Elsevier Science 🌐 English ⚖ 160 KB