𝔖 Bobbio Scriptorium
✦   LIBER   ✦

Morphology and mechanical properties of injection-molded specimens of two-phase polymer blends

✍ Scribed by C. D. Han; C. A. Villamizar; Y. W. Kim; S. J. Chen

Publisher
John Wiley and Sons
Year
1977
Tongue
English
Weight
957 KB
Volume
21
Category
Article
ISSN
0021-8995

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Microscopic mechanical properties and in
Microscopic mechanical properties and injection molding-induced morphology on polypropylene rubber blend
✍ Yutaka Kobayashi; Makoto Ando; Toshitaka Kanai 📂 Article 📅 2010 🏛 John Wiley and Sons 🌐 English ⚖ 998 KB

## Abstract A microdeformation of a simple polymer blend of polypropylene (PP) and ethylene butene rubber (EBR) was investigated in this study. Injection molding‐induced morphology close to the surface was analyzed by transmission electron microscope, polarizing optical microscope, and Fourier tran

Morphology and Mechanical Properties in
Morphology and Mechanical Properties in Polymer Blends of Photocurable Polymer and Polycarbonate
✍ Kazutaka Murata; Akiko Amamiya; Takanori Anazawa 📂 Article 📅 2003 🏛 John Wiley and Sons 🌐 English ⚖ 351 KB

## Abstract Relationships between the morphologies and mechanical properties of binary blends of a photocurable polymer (2‐propenoic acid, (octahydro‐4,7‐methano‐1H‐indenediyl) bis(methylene)ester; DCA) and a linear polymer (poly(4,4′‐cyclohexylidene bisphenol carbonate); PCz) have been investigate

Phase behavior and physical properties o
Phase behavior and physical properties of injection-molded polyamide 6/phenoxy blends
✍ G. Guerrica-Echevarría; J. I. Eguiazábal; J. Nazábal 📂 Article 📅 1999 🏛 John Wiley and Sons 🌐 English ⚖ 516 KB

Polyamide 6 (PA 6)/poly(hydroxyether of bisphenol A) (phenoxy) blends were obtained by direct injection molding over the whole composition range. Differential scanning calorimetry (DSC), dynamic mechanical thermal analysis (DMTA), and scanning electron microscopy (SEM) showed the almost full immisci