Molecular dynamics simulation of thermal conductivity of nanocrystalline composite films
β Scribed by N.A. Roberts; D.G. Walker; D.Y. Li
- Publisher
- Elsevier Science
- Year
- 2009
- Tongue
- English
- Weight
- 853 KB
- Volume
- 52
- Category
- Article
- ISSN
- 0017-9310
No coin nor oath required. For personal study only.
β¦ Synopsis
The efficiency of a thermoelectric material is measured by the figure of merit ZT, which is inversely proportional to the thermal conductivity. Superlattice structures often have a reduced thermal conductivity because of the introduction of interface scattering and, therefore, improved performance. The present work is focused on the effective thermal conductivity of nanocomposite films. This configuration could also improve ZT because of phonon-interface scattering introduced by the nanocrystals. The effects of crystal size and mass fraction are studied numerically using a molecular dynamics simulation. Results indicate that a reduction of 25% in the effective thermal conductivity can be achieved with the addition of nanocrystals which is comparable to that found in experimental measurement. However, the effective thermal conductivity was never reduced below the alloy limit.
π SIMILAR VOLUMES
## Abstract Molecular dynamics simulation using the new fit of the empirical Tersoff Potential is applied to study the thermal properties of ZnSe at and below the room temperature. The resulting diffusivity and thermal conductivity are compared with the photoacoustic measurements on the grown ZnSe
Thermal conductivity (TC) of thin films will be influenced by boundary if the thickness is close to the mean free path (MFP). In this paper, we calculate the TC of crystalline and amorphous SiO 2 thin films, which are commonly used materials in micro devices and Integrated Circuits, by nonequilibriu
## Abstract The thermal conductivity of a (5, 5) carbon nanotube at room temperature is studied by nonβequilibrium molecular dynamics simulations. The thermal conductivity increases from 30 W/(mΒ·K) to 1000 W/(mΒ·K) as the tube length increases from 6 nm to 4 Β΅m. It is proportional to the tube length