✦ LIBER ✦

Modelling of tool wear based on cutting forces in turning

✍ Scribed by H.V. Ravindra; Y.G. Srinivasa; R. Krishnamurthy

Book ID: 107873418
Publisher: Elsevier Science
Year: 1993
Tongue: English
Weight: 1010 KB
Volume: 169
Category: Article
ISSN: 0043-1648
DOI: 10.1016/0043-1648(93)90387-2

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Chip formation, cutting forces, and tool

Chip formation, cutting forces, and tool wear in turning of Zr-based bulk metallic glass

✍ Mustafa Bakkal; Albert J Shih; Ronald O Scattergood 📂 Article 📅 2004 🏛 Elsevier Science 🌐 English ⚖ 677 KB

Cutting forces in turning of gray cast i

Cutting forces in turning of gray cast iron using silicon nitride based cutting tool

✍ J.V.C. Souza; M.C.A. Nono; M.V. Ribeiro; J.P.B. Machado; O.M.M. Silva 📂 Article 📅 2009 🏛 Elsevier Science ⚖ 374 KB

Development of models for tool wear forc

Development of models for tool wear force relationships in metal cutting

✍ S.E. Oraby; D.R. Hayhurst 📂 Article 📅 1991 🏛 Elsevier Science 🌐 English ⚖ 913 KB

Modelling of CBN tool crater wear in fin

Modelling of CBN tool crater wear in finish hard turning

✍ Yong Huang; Steven Y. Liang 📂 Article 📅 2004 🏛 Springer 🌐 English ⚖ 977 KB

Modeling of cutting forces in near dry m

Modeling of cutting forces in near dry machining under tool wear effect

✍ Kuan-Ming Li; Steven Y. Liang 📂 Article 📅 2007 🏛 Elsevier Science 🌐 English ⚖ 783 KB

Tool wear effect on cutting forces: In r

Tool wear effect on cutting forces: In routing process of Aleppo pine wood

✍ H. Aknouche; A. Outahyon; C. Nouveau; R. Marchal; A. Zerizer; J.C. Butaud 📂 Article 📅 2009 🏛 Elsevier Science 🌐 English ⚖ 646 KB

This paper uses the cutting forces in a routing process of Aleppo pine wood to estimate the tool wear effect. The aim is to obtain further information about the tool wear effect by monitoring the variation in the cutting forces. A Kistler 9257A 3 axes Dynamometer was positioned under the workpiece t