✦ LIBER ✦

Modeling of cutting force under the tool flank wear effect in end milling Ti6Al4V with solid carbide tool

✍ Scribed by Sun, Yujing; Sun, Jie; Li, Jianfeng; Li, Weidong; Feng, Bin

Book ID: 121602415
Publisher: Springer
Year: 2013
Tongue: English
Weight: 896 KB
Volume: 69
Category: Article
ISSN: 0268-3768
DOI: 10.1007/s00170-013-5228-y

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Influence of cutting speed on cutting fo

Influence of cutting speed on cutting force, flank temperature, and tool wear in end milling of Ti-6Al-4V alloy

✍ Hou, Junzhan; Zhou, Wei; Duan, Hongjian; Yang, Guang; Xu, Hongwei; Zhao, Ning 📂 Article 📅 2013 🏛 Springer 🌐 English ⚖ 889 KB

Tool wear and cutting forces variation i

Tool wear and cutting forces variation in high-speed end-milling Ti-6Al-4V alloy

✍ S. Zhang; J. F. Li; J. Sun; F. Jiang 📂 Article 📅 2009 🏛 Springer 🌐 English ⚖ 511 KB

An experimental investigation of effects

An experimental investigation of effects of cooling/lubrication conditions on tool wear in high-speed end milling of Ti-6Al-4V

✍ Y. Su; N. He; L. Li; X.L. Li 📂 Article 📅 2006 🏛 Elsevier Science 🌐 English ⚖ 319 KB

High-speed machining of titanium alloys generates high cutting temperature in the cutting zone, which decreases tool life rapidly. So the improvement of the tool life in the high-speed machining of titanium alloys very much depends on the effectiveness of the cooling/lubrication provided. In this pa

A comparative study of the cutting force

A comparative study of the cutting forces in high speed machining of Ti–6Al–4V and Inconel 718 with a round cutting edge tool

✍ N. Fang; Q. Wu 📂 Article 📅 2009 🏛 Elsevier Science 🌐 English ⚖ 613 KB