✦ LIBER ✦

Modeling of carbonic acid pretreatment process using ASPEN-plusŖ

✍ Scribed by Kemantha Jayawardhana; G. Peter Van Walsum

Book ID: 111634450
Publisher: Springer-Verlag
Year: 2004
Tongue: English
Weight: 191 KB
Volume: 115
Category: Article
ISSN: 0273-2289
DOI: 10.1385/abab:115:1-3:1087

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Use of the ASPEN Plus Process Simulator

Use of the ASPEN Plus Process Simulator in Modeling Systems Containing Hydrofluoric Acid

✍ R. S. Basu; R. R. Singh; R. A. Smith 📂 Article 📅 2001 🏛 Springer 🌐 English ⚖ 245 KB

Modeling of a Low Temperature Pyrolysis

Modeling of a Low Temperature Pyrolysis Process Using ASPEN PLUS

✍ Yan, H. M.; Zhang, D. K. 📂 Article 📅 2008 🏛 Curtin University of Technology 🌐 English ⚖ 534 KB

Comparison of aspen wood hydrolysates pr

Comparison of aspen wood hydrolysates produced by pretreatment with liquid hot water and carbonic acid

✍ Robert C. McWilliams; G. Peter van Walsum 📂 Article 📅 2002 🏛 Springer-Verlag 🌐 English ⚖ 146 KB

Initial design of a dilute sulfuric acid

Initial design of a dilute sulfuric acid pretreatment process for aspen wood chips

✍ R. Torget; M. Himmel; J. D. Wright; K. Grohmann 📂 Article 📅 1988 🏛 Springer-Verlag 🌐 English ⚖ 786 KB

Defatting of annatto seeds using supercr

Defatting of annatto seeds using supercritical carbon dioxide as a pretreatment for the production of bixin: Experimental, modeling and economic evaluation of the process

✍ Carolina L.C. Albuquerque; M. Angela A. Meireles 📂 Article 📅 2012 🏛 Elsevier Science 🌐 English ⚖ 683 KB

Electrospinning of Polyaniline/Poly(Lact

Electrospinning of Polyaniline/Poly(Lactic Acid) Ultrathin Fibers: Process and Statistical Modeling using a Non-Gaussian Approach

✍ Paulo H. S. Picciani; Bluma G. Soares; Eliton S. Medeiros; Fernando G. de Souza 📂 Article 📅 2009 🏛 John Wiley and Sons 🌐 English ⚖ 719 KB

## Abstract Fibers of poly(lactic acid) (PLA) blended with p‐toluenesulfonic acid‐doped polyaniline, PAni.TSA, were obtained by electrospinning, following a factorial design which was used mainly to study the effect of four process parameters (PLA solution concentration, PAni solution concentration