✦ LIBER ✦

Model-based form error compensation in the turning of thin-walled cylindrical parts

✍ Scribed by U. Heisel; C. Kang

Publisher: Springer-Verlag
Year: 2010
Tongue: English
Weight: 902 KB
Volume: 5
Category: Article
ISSN: 0944-6524
DOI: 10.1007/s11740-010-0288-4

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Unavoidable geometric errors in the side

Unavoidable geometric errors in the side walls of end-milled parts-cylindrical surface-

✍ Kun Sang Lee; Kang Kim 📂 Article 📅 2008 🏛 Springer-Verlag 🌐 English ⚖ 562 KB

Dynamic modeling for the prediction of s

Dynamic modeling for the prediction of surface errors in the milling of thin-walled sections

✍ M.A. Elbestawi; R. Sagherian 📂 Article 📅 1991 🏛 Elsevier Science 🌐 English ⚖ 661 KB

In this paper, computer simulation techniques capable of predicting, off-line, the resulting geometric errors in the finish end-milling of thin-walled sections are presented. The effects of workpiece and cutter dynamic deflections on the chip load are included in the model. The workpiece dynamics ar