๐”– Bobbio Scriptorium
โœฆ   LIBER   โœฆ

Mode II fracture toughness of 4340 steel

โœ Scribed by N. Tsangarakis

Publisher
Elsevier Science
Year
1985
Tongue
English
Weight
764 KB
Volume
22
Category
Article
ISSN
0013-7944

No coin nor oath required. For personal study only.

๐Ÿ“œ SIMILAR VOLUMES

Fracture behavior of 4340 steel under mo
Fracture behavior of 4340 steel under mode III loading
โœ N. Tsangarakis ๐Ÿ“‚ Article ๐Ÿ“… 1982 ๐Ÿ› Elsevier Science ๐ŸŒ English โš– 281 KB

An experimental investigation was conducted to examine how the upper stress intensity factor in parallel shear KrrrQ (similar to KrQ for Mode I) is affected by increasing the tensile strength of a material. Round notched and precracked bar specimens, fabricated from 4340 steel were used for the inve

Fracture toughness of laminated steels
Fracture toughness of laminated steels
โœ N.G. Ohlson ๐Ÿ“‚ Article ๐Ÿ“… 1974 ๐Ÿ› Elsevier Science ๐ŸŒ English โš– 929 KB

Lamination occurs spontaneously in the transverse direction in many commercially available steel plates, if the transverse stresses are sufficiently high. Previous investigations have indicated that lamination is often accompanied by an improvement in the fracture toughness of the plate material. In

Fracture toughness of unidirectional fib
Fracture toughness of unidirectional fibre reinforced composites in MODE II
โœ G.S. Giare ๐Ÿ“‚ Article ๐Ÿ“… 1984 ๐Ÿ› Elsevier Science ๐ŸŒ English โš– 767 KB

## A~~act-Expe~mental investigations have been performed on unidirectional glass fibre reinforced/epoxy composites in Mode II (Forward shear) with the presence of crack parallel to the fibres direction through the use of end-cracked beam. A concentrated load at the Centre of the beam produced endi