𝔖 Bobbio Scriptorium
✦   LIBER   ✦

Minimization of entropy generation in flat heat pipe

✍ Scribed by P. Maheshkumar; C. Muraleedharan


Publisher
Elsevier Science
Year
2011
Tongue
English
Weight
374 KB
Volume
54
Category
Article
ISSN
0017-9310

No coin nor oath required. For personal study only.


πŸ“œ SIMILAR VOLUMES


Entropy generation minimization in paral
✍ Juan Carlos OrdΓ³Γ±ez; Adrian Bejan πŸ“‚ Article πŸ“… 2000 πŸ› John Wiley and Sons 🌐 English βš– 190 KB

This paper shows that the main architectural features of a counter#ow heat exchanger can be determined based on thermodynamic optimization subject to volume constraint. It is assumed that the channels are formed by parallel plates, the two #uids are ideal gases, and the #ow is fully developed, lamin

Experiments and entropy generation minim
✍ R.T. Ogulata; F. Doba πŸ“‚ Article πŸ“… 1998 πŸ› Elsevier Science 🌐 English βš– 675 KB

This paper presents a cross-flow plate type heat exchanger which has been studied and manufactured in the laboratory conditions because of its effective use in waste heat recovery systems. This new heat exchanger is tested with an applicable experimental set up, considering temperatures, velocity of

Performance of flat micro-heat pipe
✍ J. Sotani; K. Nanba; Y. Kasagi; K. Yoshioka πŸ“‚ Article πŸ“… 1993 πŸ› Elsevier Science 🌐 English βš– 104 KB
Entropy generation minimization on CIC (
✍ Sangkwon Jeong πŸ“‚ Article πŸ“… 1999 πŸ› Elsevier Science 🌐 English βš– 159 KB

The concept of EGM (Entropy Generation Minimization) is applied to the design of an optimum CIC (Cable-In-Conduit) superconducting cable for large scale superconducting magnets, which is cooled by supercritical helium flow inside a conduit at cryogenic temperature. Three factors are considered to ev

Heat transfer to power-law fluids flowin
✍ A.F. Flores; J.C. Gottifredi; G.V. Morales; O.D. Quiroga πŸ“‚ Article πŸ“… 1991 πŸ› Elsevier Science 🌐 English βš– 670 KB

This paper aims to show the application of the analytical approach presented recently by Gottifredi et al. [lnt. J. Heat Mass Trans@ 26, 1215-1220 (1983)] to the generalized Graetz-Nusselt problem, in order to estimate the mixing-cup temperature of a power-law fluid which is flowing through a duct w