Microstructure change in the interface of co2 laser welded zirconium alloys

✍ Scribed by N. Boutarek; B. Azzougui; D. Saidi; M. Neggache

• Publisher: Elsevier
• Year: 2009
• Tongue: English
• Weight: 882 KB
• Volume: 2
• Category: Article
• ISSN: 1875-3892
• DOI: 10.1016/j.phpro.2009.11.078

✦ Synopsis

Welding is a joining procedure that offers some benefits over mechanical fasteners such as weight reduction and absence of notches induced by machining operations. CO 2 laser beam welding with a continuous wave is a high energy density and low heat input process. The result of this is a small heat-affected zone (HAZ), which cools very rapidly with very little distortion, and a high depth-to-width ratio for the Welding is a necessary process during fabricating fuel rods and fuel assemblies with Zircaloy-4 cladding, and electron beam welding is one of the commonly-used method. In this work, the joining of zirconium alloys was attempted by laser beam welding. A 2 kW CO 2 laser is used and the joints are obtained from similar materials, which are plates of Zircaloy-4 (2 mm thick). A series of zirconium alloys were welded and investigated in a tow-fold approach: (1) process optimisation: the laser processing parameters are optimized to obtain welds with minimum defects, and (2) material characterisation: weld microstructures were evaluated. The microstructure and the phases present in the resolidified zone of the laser -welded specimens were analyzed by optical and scanning electron microscopy, X-ray diffraction, and also by the realization of micro hardness diagrams. A particular attention was made to study the correlation between surface structure and mechanical behaviour.