𝔖 Bobbio Scriptorium
✦   LIBER   ✦

Microstructure and heat resistance of Mg–Al–Zn alloys containing metastable phase

✍ Scribed by Jeong-Min Kim; Bong-Koo Park; Joong-Hwan Jun; Keesam Shin; Ki-Tae Kim; Woon-Jae Jung


Publisher
Elsevier Science
Year
2007
Tongue
English
Weight
826 KB
Volume
449-451
Category
Article
ISSN
0921-5093

No coin nor oath required. For personal study only.

✦ Synopsis


In this research microstructural studies have been made on cast specimens of AZ91 base alloys containing various amounts of Zn. As the amount of Zn addition increased up to 2%, any new Zn-containing phase did not appear while the Zn content in Mg 17 Al 12 phase continuously increased. A quasi-crystalline phase started to form at Mg 17 Al 12 phase when the added Zn content was about 3 wt.%. The tensile strength and elongation of the alloys at 175 • C were observed to increase significantly with increasing Zn content. The quasi-crystalline phase was found to be stable up to 300 • C, based on scanning electron microscopy examinations of the specimens heated at different temperatures for 24 h.


📜 SIMILAR VOLUMES


Pitting and repassivation processes of A
✍ P.L. Cabot; F.A. Centellas; E. Pérez; R. Loukili 📂 Article 📅 1993 🏛 Elsevier Science 🌐 English ⚖ 547 KB

Almtraet--The mechanism of localized corrosion of AI-5.03%Zn-l.67%Mg--0.23%Cu alloy submitted to different heat treatments (annealed (A); cold-rolled (ST); quenched (F); quenched and aged (13); and quenched in two stages and aged ((2)) in NaCI, NaaSO 4 and in NaCI-Na2SO 4 solutions has been studied

Effects of Sn and Ca additions on micros
✍ C. Jihua; C. Zhenhua; Y. Hongge; Z. Fuquan; C. Yingliang 📂 Article 📅 2008 🏛 John Wiley and Sons 🌐 German ⚖ 972 KB

## Abstract Effects of Sn and Ca additions on microstructure, mechanical properties, and corrosion resistance of the as‐cast Mg‐6Zn‐2Al‐based alloy were investigated by SEM, XRD, tensile tests, electrochemical measurements, etc. The higher the Sn content, the higher the yield strength of the Mg‐6Zn