Abstract
Our purpose in this study was to determine the microhardness of superficial and deep dentin by means of two indentation methods (Knoop and Vickers) under two different applied loads. Twelve dentin discs approximately 2βmm thick were obtained from both superficial and deep dentin by transversally sectioning the crowns of sound, extracted human third molars with a diamond blade under water irrigation. Dentin surfaces were sequentially polished, and indentations (n = 20 per surface) were performed with either Vickers indentor at loads of 300 and 500 g, respectively, or Knoop indentor at loads of 50 and 100 g, respectively. Average Vickers hardness number (VHN) and Knoop hardness number (KHN) were calculated and treated with twoβway analysis of variance (ANOVA) and Student's t test. Microhardness of dentin was not influenced by the different loads applied for both indentation methods. Knoop hardness was significantly higher for superficial than for deep dentin (p < 0.05). Conversely, Vickers hardness was not significantly different for both substrates (p > 0.05). Differences in dentin hardness as a function of depth exist, but they might not be relevant, and no alteration of the distribution of stresses along the adhesive interface is expected. Β© 2003 Wiley Periodicals, Inc. J Biomed Mater Res 66A: 850β853, 2003