𝔖 Bobbio Scriptorium
✦   LIBER   ✦

Micro powder injection moulding

✍ Scribed by Rudolf Zauner

Publisher
Elsevier Science
Year
2006
Tongue
English
Weight
210 KB
Volume
83
Category
Article
ISSN
0167-9317

No coin nor oath required. For personal study only.

πŸ“œ SIMILAR VOLUMES

Characterisation of micro gears produced
Characterisation of micro gears produced by micro powder injection moulding
✍ B.Y. Tay; N.H. Loh; S.B. Tor; F.L. Ng; G. Fu; X.H. Lu πŸ“‚ Article πŸ“… 2009 πŸ› Elsevier Science 🌐 English βš– 564 KB

The paper describes the fabrication of micro gears of diameter and height 1 mm by micro powder injection moulding. 316L stainless steel powder of 2.4 Β΅m (d 50 ) is mixed with a multi-component wax-based binder system. The feedstock is then injection-moulded into micro gears followed by debinding and

Micro Powder Injection Molding
Micro Powder Injection Molding
✍ V. Piotter; T. Benzler; T. Gietzelt; R. Ruprecht; J. Haußelt πŸ“‚ Article πŸ“… 2000 πŸ› John Wiley and Sons 🌐 English βš– 243 KB πŸ‘ 1 views
Metal injection moulding of gamma titani
Metal injection moulding of gamma titanium aluminide alloy powder
✍ R. Gerling; E. Aust; W. Limberg; M. Pfuff; F.P. Schimansky πŸ“‚ Article πŸ“… 2006 πŸ› Elsevier Science 🌐 English βš– 413 KB

Fine alloy powder with the nominal composition Ti 47Al 4(Mn,Cr,Nb,Si,B) (at%) has been produced by argon gas atomization and processed by metal injection moulding. The main objective of process optimization concerned the level of the impurity pick-up and the influence of sintering atmosphere on poro