๐”– Bobbio Scriptorium
โœฆ   LIBER   โœฆ

Micro injection molding of micro gear using nano-sized zirconia powder

โœ Scribed by P. C. Yu; Q. F. Li; J. Y. H. Fuh; T. Li; P. W. Ho

Publisher
Springer-Verlag
Year
2008
Tongue
English
Weight
314 KB
Volume
15
Category
Article
ISSN
0946-7076

No coin nor oath required. For personal study only.

๐Ÿ“œ SIMILAR VOLUMES

Characterisation of micro gears produced
Characterisation of micro gears produced by micro powder injection moulding
โœ B.Y. Tay; N.H. Loh; S.B. Tor; F.L. Ng; G. Fu; X.H. Lu ๐Ÿ“‚ Article ๐Ÿ“… 2009 ๐Ÿ› Elsevier Science ๐ŸŒ English โš– 564 KB

The paper describes the fabrication of micro gears of diameter and height 1 mm by micro powder injection moulding. 316L stainless steel powder of 2.4 ยตm (d 50 ) is mixed with a multi-component wax-based binder system. The feedstock is then injection-moulded into micro gears followed by debinding and

Constitutive modelling of microstructure
Constitutive modelling of microstructured components fabricated by micro powder injection molding
โœ L. Liu; N.H. Loh; B.Y. Tay; S.B. Tor; Y. Murakoshi; R. Maeda ๐Ÿ“‚ Article ๐Ÿ“… 2008 ๐Ÿ› Elsevier Science ๐ŸŒ English โš– 597 KB

A constitutive model based on Besson and Abouaf's constitutive equation was established to simulate densification of 316L stainless steel microstructured components fabricated by micro powder injection molding. A new sintering stress expression for final stage sintering was established by including

Effects of mold dimensions on rheologica
Effects of mold dimensions on rheological of feedstock in micro powder injection molding
โœ Qing Wang; Haiqing Yin; Xuanhui Qu; John L. Johnson ๐Ÿ“‚ Article ๐Ÿ“… 2009 ๐Ÿ› Elsevier Science ๐ŸŒ English โš– 988 KB

Micro powder injection molding (ยตPIM) differs from conventional powder injection molding (PIM) with respect to the effects of the mold dimensions. In this study, the rheological properties of the feedstock (mixture of carbonyl iron powders and binder) in molds with different diameters were analyzed