✦ LIBER ✦

Measurement of wear in small bores

✍ Scribed by K. Narayanasamy; V. Radhakrishnan

Publisher: Elsevier Science
Year: 1978
Tongue: English
Weight: 487 KB
Volume: 49
Category: Article
ISSN: 0043-1648
DOI: 10.1016/0043-1648(78)90090-x

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Surface replication studies of small bor

Surface replication studies of small bores

✍ K. Narayanasamy; V. Radhakrishnan 📂 Article 📅 1980 🏛 Elsevier Science 🌐 English ⚖ 614 KB

Thermal distortions in the machining of

Thermal distortions in the machining of small bores

✍ V. Bana; B. Karpuschewski; J. Kundrák; A.M. Hoogstrate 📂 Article 📅 2007 🏛 Elsevier Science 🌐 English ⚖ 656 KB

In hard turning where the machining generally takes place without coolant, the heat removal is an especially difficult problem. In the manufacturing of bores the heat removal is more difficult than when cutting external surfaces. Moreover, if the bore diameter decreases the removal of heat generated

Wear of cylinder bore microtopography

✍ B.-G. Rosén; R. Ohlsson; T.R. Thomas 📂 Article 📅 1996 🏛 Elsevier Science 🌐 English ⚖ 926 KB

Bearing length ratio applied to the meas

Bearing length ratio applied to the measurement of engine cylinder-bore wear

✍ Richard A. Daskivich 📂 Article 📅 1984 🏛 Elsevier Science 🌐 English ⚖ 286 KB

Wear measurements of self-lubricating be

Wear measurements of self-lubricating bearing materials in small oscillatory movement

✍ R. Gawarkiewicz; M. Wasilczuk 📂 Article 📅 2007 🏛 Elsevier Science 🌐 English ⚖ 833 KB

During last decades the interest in self-lubricating materials was increased because of ecological reasons. An example is the tendency to replace grease-lubricated bearings with self-lubricated ones in guide vanes of water turbines. However, in some cases, greaseless materials did not meet durabilit

Ultrasonic measurement of wear

✍ A.S. Birring; H. Kwun 📂 Article 📅 1989 🏛 Elsevier Science 🌐 English ⚖ 424 KB