## Abstract The large‐signal modulation response of a 1.3 μm InGaAsP four‐well laser of the Fabry–Perot type is investigated when the input signal is either a sinusoidal or a square wave. The time evolution of the photon density is obtained by the numerical solution of the rate equations for severa
Measurement of recombination coefficients of both 1.3-μm and 1.5-μm InGaAsP laser diodes
✍ Scribed by Wataru Hidaka; Wataru Susaki
- Publisher
- John Wiley and Sons
- Year
- 1997
- Tongue
- English
- Weight
- 183 KB
- Volume
- 80
- Category
- Article
- ISSN
- 8756-663X
No coin nor oath required. For personal study only.
✦ Synopsis
This study concerns InGaAsP laser diodes with ptype substrates and with leak currents that can be ignored at room temperature. We investigate the radiative recombination coefficient and the Auger recombination coefficient based on the delay time of laser oscillation from the pulse current applied to the laser diode. The experimental value of the oscillation delay time is compared to the calculated value obtained by numerically solving the rate equation with respect to the impressed pulse current waveform. The 1.3 mm-PBC and 1.5 mm-PPIBH-InGaAsP laser diodes used in the experiment have a threshold carrier density n t of (2.83) ´ 10 18 /cm 3 . The radiative recombination coefficient B and the Auger recombination coefficient A of these diodes are determined as (11.5) ´ 10 10 cm 3 /s and < 0.05 ´ 10 28 cm 6 /s, respectively. In other words, it is seen that the Auger recombination term An t 3 is negligibly small compared to the radiative recombination term Bn t 2 .
📜 SIMILAR VOLUMES
We have measured the change in threshold current and lasing photon energy as a function of pressure in 1.3 mm semiconductor quantum well lasers. We observe a decrease in threshold current with increasing pressure indicative of an Auger recombination process which decreases as the band gap increases.