๐”– Bobbio Scriptorium
โœฆ   LIBER   โœฆ

MEASURED FREE VIBRATIONS OF PARTIALLY CLAMPED, SQUARE PLATES

โœ Scribed by J.F. WILSON; J.K. HENRY; R.L. CLARK


Publisher
Elsevier Science
Year
2000
Tongue
English
Weight
397 KB
Volume
231
Category
Article
ISSN
0022-460X

No coin nor oath required. For personal study only.

โœฆ Synopsis


Experiments were designed to measure the free, transverse vibrations for square, thin elastic plates with two types of edge support con"gurations. One con"guration was fully clamped on three edges and free on the fourth edge (CCCF), and the other was fully clamped on two adjacent edges and free on the other two edges (CCFF). For these respective con"gurations, up to 18 frequencies and the corresponding modal contours were measured using a scanning laser-doppler velocimeter, acoustic excitation, and computer software. Measurements for the lowest "ve non-dimensional frequency parameters and their node lines compared favorably to the corresponding theoretical results available in the open literature. Curve veering may be the reason that several of the crisp modal contours at some higher excitation frequencies for the CCFF con"guration were observed to be neither symmetric nor antisymmetric about the plate's diagonal line of geometric symmetry.


๐Ÿ“œ SIMILAR VOLUMES


FREE VIBRATIONS OF CLAMPED SYMMETRICALLY
โœ K. Hosokawa; Y. Terada; T. Sakata ๐Ÿ“‚ Article ๐Ÿ“… 1996 ๐Ÿ› Elsevier Science ๐ŸŒ English โš– 368 KB

Free vibrations of a fully clamped symmetrically laminated skew plate are analyzed by a numerical approach in which the Green function for a static bending problem is used. As a numerical example, results are presented for a three-layered symmetrically laminated skew plate. The effects of the skew a

FREE VIBRATION OF PARTIALLY CLAMPED RECT
โœ R.K. Singhal; D.J. Gorman ๐Ÿ“‚ Article ๐Ÿ“… 1997 ๐Ÿ› Elsevier Science ๐ŸŒ English โš– 222 KB

An analytical procedure based on the method of superposition is described for obtaining the free vibration frequencies and mode shapes of partially clamped cantilevered rectangular plates with and without rigid point supports. The supports are of the type provided by bolts with stand-offs. Good agre

FREE VIBRATION OF ORTHOTROPIC SQUARE PLA
โœ T. SAKIYAMA; M. HUANG; H. MATSUDA; C. MORITA ๐Ÿ“‚ Article ๐Ÿ“… 2003 ๐Ÿ› Elsevier Science ๐ŸŒ English โš– 323 KB

An approximate method is extended for analyzing the free vibration problem of orthotropic square plate with a square hole. In this paper, a square plate with a square hole is transformed into an equivalent square plate with non-uniform thickness by considering the hole as an extremely thin part of t

A Partial Hybrid Plate Element Formulati
โœ Y.-P. Tseng; L.-C. Chou ๐Ÿ“‚ Article ๐Ÿ“… 1993 ๐Ÿ› Elsevier Science ๐ŸŒ English โš– 439 KB

A partial hybrid plate element vibration analysis is established for orthotropic laminated plates. The inertia effect is considered by adding kinetic energy to the modified HellingerReissner principle. The dynamic governing equations of the plate are then derived variationally. As the through-thickn