✦ LIBER ✦

Mean stress effects on flow localization and failure in a bulk metallic glass

✍ Scribed by K.M. Flores; R.H. Dauskardt

Publisher: Elsevier Science
Year: 2001
Tongue: English
Weight: 350 KB
Volume: 49
Category: Article
ISSN: 1359-6454
DOI: 10.1016/s1359-6454(01)00125-2

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Effect of loading rate on failure in Zr-

Effect of loading rate on failure in Zr-based bulk metallic glass

✍ Y.F. Xue; H.N. Cai; L. Wang; F.C. Wang; H.F. Zhang 📂 Article 📅 2008 🏛 Elsevier Science 🌐 English ⚖ 676 KB

Effects of Temperatures on Inhomogeneous

Effects of Temperatures on Inhomogeneous Plastic Flows of a Bulk-Metallic Glass

✍ W. H. Jiang; F. X. Liu; D. C. Qiao; H. Choo; P. K. Liaw; R. Li; T. Zhang 📂 Article 📅 2008 🏛 John Wiley and Sons 🌐 English ⚖ 305 KB 👁 2 views

Effect of loading rate on the serrated f

Effect of loading rate on the serrated flow of a bulk metallic glass during nanoindentation

✍ T. Burgess; K.J. Laws; M. Ferry 📂 Article 📅 2008 🏛 Elsevier Science 🌐 English ⚖ 342 KB

The nature of displacement burst features throughout the load-controlled instrumented indentation of a Mg 65 Cu 25 Y 10 bulk metallic glass was investigated over four decades of loading rate with varying peak loads and tip geometry. Where observed in the load-displacement data, displacement burst fr

Devitrification and Cooling Rate Effects

Devitrification and Cooling Rate Effects on Microstructure and Mechanical Properties in Fe57C9B11Mo12Cr8W3 Bulk Metallic Glass

✍ H. E. Khalifa; K. S. Vecchio 📂 Article 📅 2008 🏛 John Wiley and Sons 🌐 English ⚖ 721 KB

Fig. 3. XRD spectra of Fe 57 C 9 B 11 Mo 12 Cr 8 W 3 after 5 min anneals at successive step 10 K intervals above T g (814 K). The 874 K anneal is 7 K above T × (867 K).

Loading rate effect on inelastic deforma

Loading rate effect on inelastic deformation in a Zr-based bulk metallic glass

✍ Y.-H. Lee; J.-Y. Kim; S.H. Nahm; D. Kwon 📂 Article 📅 2007 🏛 Elsevier Science 🌐 English ⚖ 505 KB

Effects of a minor addition of Si and/or

Effects of a minor addition of Si and/or Sn on formation and mechanical properties of Cu–Zr–Ti bulk metallic glass

✍ T. Zhang; H. Men; S.J. Pang; J.Y. Fu; C.L. Ma; A. Inoue 📂 Article 📅 2007 🏛 Elsevier Science 🌐 English ⚖ 980 KB

Effects of the addition of a small amount of Sn and/or Si on glass-forming ability and mechanical properties of Cu 50 Zr 42.5 Ti 7.5 (at.%) bulk metallic glass were studied. The critical diameter for glass formation is 5 mm for Cu 50 Zr 42.5 Ti 7.5 alloy, and increases to 6 mm for (Cu 0.5 Zr 0.425 T