✦ LIBER ✦

Maximization of process tolerances using an analysis of setup capability

✍ Scribed by F. González Contreras

Book ID: 120742530
Publisher: Springer
Year: 2012
Tongue: English
Weight: 472 KB
Volume: 67
Category: Article
ISSN: 0268-3768
DOI: 10.1007/s00170-012-4638-6

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

An improved tolerance charting technique

An improved tolerance charting technique using an analysis of setup capability

✍ F. González Contreras 📂 Article 📅 2012 🏛 Springer 🌐 English ⚖ 471 KB

Process capability analysis of non-norma

Process capability analysis of non-normal process data using the Burr XII distribution

✍ Pei-Hsi Liu; Fei-Long Chen 📂 Article 📅 2005 🏛 Springer 🌐 English ⚖ 404 KB

Elemental analysis of concrete samples u

Elemental analysis of concrete samples using an accelerator-based PGNAA setup

✍ A.A. Naqvi; M.M. Nagadi; Omar S. Baghabra Al-Amoudi 📂 Article 📅 2004 🏛 Elsevier Science 🌐 English ⚖ 407 KB

Elemental analysis of concrete samples was carried out using an accelerator-based prompt gamma ray neutron activation analysis (PGNAA) setup. The gamma rays were produced via the capture of thermal neutron in the concrete sample. The prompt gamma ray yield was measured for 12 cm long concrete sample

Tolerance optimization of a lower arm by

Tolerance optimization of a lower arm by using genetic algorithm and process capability index

✍ Lee, Kwang-Ki; Ro, Yun-Cheol; Han, Seung-Ho 📂 Article 📅 2014 🏛 Korean Society for Precision Engineering 🌐 English ⚖ 885 KB

Multivariate process capability using pr

Multivariate process capability using principal component analysis in the presence of measurement errors

✍ Michele Scagliarini 📂 Article 📅 2011 🏛 Springer-Verlag 🌐 English ⚖ 541 KB

An Investigation into the Variability of

An Investigation into the Variability of Breast Tangent Setups Using the Portal Imaging Process

✍ Turner, Angela S.; Goodbrand, Anne; Di Prospero, Lisa 📂 Article 📅 2011 🏛 Elsevier Science 🌐 English ⚖ 317 KB