✦ LIBER ✦

Materials and constructions used in devices to prevent the spread of flames in pipelines and vessels

✍ Scribed by K.L Edwards; M.J Norris

Publisher: Elsevier Science
Year: 1999
Weight: 885 KB
Volume: 20
Category: Article
ISSN: 0261-3069
DOI: 10.1016/s0261-3069(99)00004-7

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Orthetic devices to prevent deformities

Orthetic devices to prevent deformities of the hand in rheumatoid arthritis

✍ Robert L. Bennett 📂 Article 📅 1965 🏛 John Wiley and Sons 🌐 English ⚖ 914 KB

IMPLE ORTHETIC DEVICES can be made for the fingers and thumb S that will permit necessary functional use but prevent most of the persistent positions of fault that could lead to structural deformity. It therefore seems reasonable to believe that if these devices can be fitted at the earliest signs o

Effects of ignition and wind on the tran

Effects of ignition and wind on the transition to flame spread in a microgravity environment

✍ K.B. McGrattan; T. Kashiwagi; H.R. Baum; S.L. Olson 📂 Article 📅 1996 🏛 Elsevier Science 🌐 English ⚖ 47 KB

A two-dimensional, time-dependent model is developed describing ignition and the subsequent transition to flame spread over a thermally thin cellulosic sheet heated by external radiation in a microgravity environment. The effects of a slow external wind (0-5 cm/s), and of the flux distribution of th

96/06353 Effects of ignition and wind on

96/06353 Effects of ignition and wind on the transition to flame spread in a microgravity environment

📂 Article 📅 1996 🏛 Elsevier Science ⚖ 199 KB

Four high-volatile bituminous coals were used to investigate the effect of different coal composition on the amount and release of fuel-nitrogen. The nitrogen content and functional groups depend on the exinite content; with increasing amounts of exinite both, the amount of total nitrogen, and the r

On the fractography of overload, stress

On the fractography of overload, stress corrosion, and cyclic fatigue failures in pyrolytic-carbon materials used in prosthetic heart-valve devices

✍ Ritchie, R. O. ;Dauskardt, R. H. ;Pennisi, F. J. 📂 Article 📅 1992 🏛 John Wiley and Sons 🌐 English ⚖ 545 KB

A scanning electron microscopy study is reported of the nature and morphology of fracture surfaces in pyrocarbons commonly u s e d for t h e m a n u f a c t u r e of mechanical heart-valve prostheses. Specifically, silicon-alloyed low-temperaturei s o t r o p i c (LT1)-pyrolytic c a r b o n is exami

On the use of secondary ion mass spectro

On the use of secondary ion mass spectrometry in semiconductor device materials and process development

✍ Charles W. Magee 📂 Article 📅 1984 🏛 Elsevier Science 🌐 English ⚖ 795 KB

Economics of MSF plants: influence of va

Economics of MSF plants: influence of variations in the design parameters and use of different construction materials

✍ S. Arazzini; R. Borsani; G. Migliorini; U. Zuboli 📂 Article 📅 1985 🏛 Elsevier Science 🌐 English ⚖ 343 KB

Different types of MSF plants are taken into consideration and a comparison between the two fundamental ones (i.e. cross-flow and long-flow) is made to find out the most economical solution. The comparison has been performed by studying and examining the different technological features of the two d