Sm 2 Fe 17Àx Ti x N compounds were prepared from the starting Sm 2 Fe 17Àx Ti x alloy by nitrogenation processes for 2, 4, 6 and 10 h. The microstructure and crystal lattice parameters of the Sm 2 Fe 17Àx Ti x N system were presented in detail. The main phase of all Sm 2 Fe 17Àx Ti x N (with x ¼ 0;
Magnetic properties and microstructure of the dual-phase nanocomposite magnet Sm3(Fe,Ti)29Nx/α-Fe
✍ Scribed by Y. Zhang; C.X. Cui; J.B. Sun; H.X. Yang; H.F. Tian; H.R. Zhang; J.Q. Li
- Publisher
- Elsevier Science
- Year
- 2006
- Tongue
- English
- Weight
- 381 KB
- Volume
- 433
- Category
- Article
- ISSN
- 0921-5093
No coin nor oath required. For personal study only.
✦ Synopsis
A new dual-phase nanocomposite magnet, made up of the well-coupled Sm 3 (Fe,Ti) 29 N x and ␣-Fe nano-crystals, has been successfully fabricated by the melt-spun technique. Measurements of magnetic properties reveal that the hysteresis loop shows up the notable characteristics of single hard magnet in the well-crystallized samples. The electron microscopy investigations indicate that the grain sizes in our samples in general range from 30 to 60 nm for Sm 3 (Fe,Ti) 29 N x and from 10 to 20 nm for ␣-Fe, grain boundaries between the Sm 3 (Fe,Ti) 29 N x and ␣-Fe phases are clean without any impurities. These structural features are fundamentally compatible with direct exchange-coupling between these two magnetic phases.
📜 SIMILAR VOLUMES
The magnetic properties of Nd 11 Fe 72Àx Co 8 V 1.5 Cr x B 7.5 (x ¼ 0,1) nanocomposites prepared by the crystallization of amorphous precursors have been investigated. It was found that Cr addition increases the crystallization temperature of the amorphous ribbons, resulting in the formation of a me
In this study, the effect of silane treatment of Fe 3 O 4 on the magnetic and wear properties of Fe 3 O 4 /epoxy nanocomposites was investigated. Fe 3 O 4 nanopowders were prepared by coprecipitation of iron(II) chloride tetrahydrate with iron(III) chloride hexahydrate, and the surfaces of Fe 3 O 4