✦ LIBER ✦

Low velocity impact of a nanoparticle on nanobeams by using a nonlocal elasticity model and explicit finite element modeling

✍ Scribed by Seifoori, S.; Liaghat, G.H.

Book ID: 119961031
Publisher: Elsevier Science
Year: 2013
Tongue: English
Weight: 954 KB
Volume: 69
Category: Article
ISSN: 0020-7403
DOI: 10.1016/j.ijmecsci.2013.01.030

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Free vibration of a pneumatic tire-wheel

Free vibration of a pneumatic tire-wheel unit using a ring on an elastic foundation and a finite element model

✍ L.E. Kung; W. Soedel; T.Y. Yang 📂 Article 📅 1986 🏛 Elsevier Science 🌐 English ⚖ 856 KB

Use of a new finite element continuity m

Use of a new finite element continuity model to study the transient behavior of ice stream C and causes of its present low velocity

✍ Fastook, J. L. 📂 Article 📅 1987 🏛 American Geophysical Union 🌐 English ⚖ 793 KB

Simulation of the thermomechanical effec

Simulation of the thermomechanical effects originated on a fuel pin with a cracked pellet by different power ramp velocities, using a two dimensional finite element model

✍ Fernando G. Basombrío 📂 Article 📅 1983 🏛 Elsevier Science 🌐 English ⚖ 386 KB

On the use of a patient-specific rapid-p

On the use of a patient-specific rapid-prototyped model to simulate the response of the human head to impact and comparison with analytical and finite element models

✍ E.A.C. Johnson; P.G. Young 📂 Article 📅 2005 🏛 Elsevier Science 🌐 English ⚖ 325 KB

A new stress-based model of friction beh

A new stress-based model of friction behavior in machining and its significant impact on residual stresses computed by finite element method

✍ Xiaoping Yang; C.Richard Liu 📂 Article 📅 2002 🏛 Elsevier Science 🌐 English ⚖ 278 KB

Friction modeling in metal cutting has been recognized as one of the most important and challenging tasks facing researchers engaged in modeling of machining operations. To address this issue from the perspective of predicting machining induced residual stresses, a new stress-based polynomial model