Low-molar-mass cyclic poly(oxyethylene)s studied by Raman spectroscopy, X-ray scattering and differential scanning calorimetry
โ Scribed by Ga-Er Yu; Tao Sun; Ze-Gui Yan; Colin Price; Colin Booth; Jennifer Cook; Anthony J. Ryan; Kyriakos Viras
- Book ID
- 104164356
- Publisher
- Elsevier Science
- Year
- 1997
- Tongue
- English
- Weight
- 715 KB
- Volume
- 38
- Category
- Article
- ISSN
- 0032-3861
No coin nor oath required. For personal study only.
โฆ Synopsis
Crystalline cyclic poly(oxyethylene)s of number-average molar mass 1000, 1500, 2000 and 3000 g mol i were studied by high-frequency and low-frequency laser-Raman spectroscopy, wide-angle (WAXS) and smallangle (SAXS) X-ray scattering, and differential scanning calorimetry (d.s.c.). Comparison was made with the properties of corresponding linear poly(oxyethylene) dimethyl ethers. The crystal structures of the linear and cyclic polymers were essentially the same as that of high-molar-mass poly(oxyethylene). The cyclic polymers crystallized in the twice-folded conformation and the linear polymers in the extended conformation, as confirmed by their lamellar spacings (SAXS) and the frequencies of their single-node longitudinal acoustic modes (LAM-1). Compared at identical lamellar spacing, the cyclic polymers had identical enthalpies of fusion (per mol of chain units) as the linear polymers but higher melting temperatures, consistent with lower entropies of fusion (per mol of chain units) for the cyclic polymers.
๐ SIMILAR VOLUMES
The phase transition in [Cr(NH 3 ) 6 ](BF 4 ) 3 at T h c ยผ 238:42 K (on heating) and at T c c ยผ 237:93 K (on cooling) was determined by differential scanning calorimetry (DSC). Fourier transform far infrared (FT-FIR) and middle infrared (FT-MIR) spectra were measured in the temperature range of 20 -
In this article a study on the melting behavior and microstructure of semicrystalline poly(ethylene naphthalene-2,6-dicarboxylate) (PEN) prepared by crystallization from the glass under different annealing conditions is presented. The influence of the annealing temperature (T a ), annealing time (t