✦ LIBER ✦

Layer system for a rotor/stator seal of gas turbines

Publisher: Elsevier Science
Year: 2005
Tongue: English
Weight: 310 KB
Volume: 2005
Category: Article
ISSN: 1350-4789
DOI: 10.1016/s1350-4789(05)70911-9

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Aerodynamic aspects of the sealing of ga

Aerodynamic aspects of the sealing of gas-turbine rotor-stator systems: Part 3: The effect of nonaxisymmetric external flow on seal performance

✍ U.P. Phadke; J.M. Owen 📂 Article 📅 1988 🏛 Elsevier Science 🌐 English ⚖ 426 KB

Aerodynamic aspects of the sealing of ga

Aerodynamic aspects of the sealing of gas-turbine rotor-stator systems: Part 2: The performance of simple seals in a quasi-axisymmetric external flow

✍ U.P. Phadke; J.M. Owen 📂 Article 📅 1988 🏛 Elsevier Science 🌐 English ⚖ 672 KB

Aerodynamic aspects of the sealing of ga

Aerodynamic aspects of the sealing of gas-turbine rotor-stator systems: Part 1: The behavior of simple shrouded rotating-disk systems in a quiescent environment

✍ U.P. Phadke; J.M. Owen 📂 Article 📅 1988 🏛 Elsevier Science 🌐 English ⚖ 722 KB

New high-temperature seal system for inc

New high-temperature seal system for increased efficiency of gas turbines

✍ Dieter Sporer; Arno Refke; Marian Dratwinski; Mitch Dorfman; Sulzer Metco; Iacop 📂 Article 📅 2008 🏛 Elsevier Science 🌐 English ⚖ 641 KB

A process for sealing the rotor of a tur

A process for sealing the rotor of a turbine which uses wet geothermal steam

📂 Article 📅 1994 🏛 Elsevier Science 🌐 English ⚖ 126 KB

## Patents to 500°F (-55°C to 260°C). b,owor. o Patents A process for 1760 rpm, the maximum shaft speed in other applications can be up to This is a list of recently published sealing the rotor of 25 000 rpm or 45 m/s (150 ft/sec), patents coveting designs and inven-Other options available to incr

Leaf seal for inner and outer casings of

Leaf seal for inner and outer casings of a gas turbine

📂 Article 📅 2002 🏛 Elsevier Science 🌐 English ⚖ 460 KB

such a way that the stop element forms a first sealing surface, which lies adjacent to one section of the nozzle holder, and a second sealing surface, which lies adjacent to one section of the nozzle body. Both the first and second sealing surfaces have at least one cavity that is punched, drilled a