Latent heat thermal storage for solar dynamic power generation
β Scribed by C. Bellecci; M. Conti
- Publisher
- Elsevier Science
- Year
- 1993
- Tongue
- English
- Weight
- 350 KB
- Volume
- 51
- Category
- Article
- ISSN
- 0038-092X
No coin nor oath required. For personal study only.
π SIMILAR VOLUMES
Wallboard impregnated with phase change material (PCM) will provide thermal storage that is distributed throughout a building, enabling passive solar design and off-peak cooling with frame construction. This paper examines the thermal dynamics of PCM wallboard that is subjected to the diurnal variat
Accelerated thermal cycle tests for melt/freeze cycles of urea were conducted. Urea has shown a very high degradation in its latent heat and melting point within the "rst few cycles and did not melt after a few cycles. It is recommended that urea should not be used as a latent heat storage material.
For wide use of a power plant utilizing solar energy, improvement of its economics is important. Both the economics and characteristics of a CO 2 -capturing solar thermal hybrid power generation system are evaluated in this paper. Since a relatively low temperature steam of 220 Β°C is produced by usi