✦ LIBER ✦

Investigation of tool wear and surface integrity on MQL machining of Ti-6AL-4V using biodegradable oil

✍ Scribed by Rahim, E. A. (author);Sasahara, H. (author)

Book ID: 126002833
Publisher: SAGE Publications
Year: 2011
Tongue: English
Weight: 630 KB
Volume: 225
Category: Article
ISSN: 0954-4054
DOI: 10.1177/0954405411402554

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Investigation of tool wear and surface i

Investigation of tool wear and surface integrity on MQL machining of Ti-6AL-4V using biodegradable oil

✍ Rahim, E. A. (author);Sasahara, H. (author) 📂 Article 📅 2011 🏛 SAGE Publications 🌐 English ⚖ 630 KB

Investigations on Mechanisms of Tool Wea

Investigations on Mechanisms of Tool Wear in Machining of Ti-6Al-4V Using FEM Simulation

✍ Zanger, F.; Schulze, V. 📂 Article 📅 2013 🏛 Elsevier 🌐 English ⚖ 460 KB

Investigation on surface grinding of Ti-

Investigation on surface grinding of Ti-6Al-4V using minimum quantity lubrication

✍ Guo, qiang; Liu, Zhiqiang; An, Qinglong; Chen, Ming 📂 Article 📅 2012 🏛 Inderscience Publishers 🌐 English ⚖ 128 KB

A comparative study of high-speed machin

A comparative study of high-speed machining of Ti-6Al-4V and Inconel 718—part II: Effect of dynamic tool edge wear on cutting vibrations

✍ N. Fang, P. Srinivasa Pai, N. Edwards 📂 Article 📅 2013 🏛 Springer 🌐 English ⚖ 424 KB

A comparative study of high-speed machin

A comparative study of high-speed machining of Ti–6Al–4V and Inconel 718 - part I: effect of dynamic tool edge wear on cutting forces

✍ N. Fang, P. Srinivasa Pai, N. Edwards 📂 Article 📅 2013 🏛 Springer 🌐 English ⚖ 479 KB

An experimental investigation of effects

An experimental investigation of effects of cooling/lubrication conditions on tool wear in high-speed end milling of Ti-6Al-4V

✍ Y. Su; N. He; L. Li; X.L. Li 📂 Article 📅 2006 🏛 Elsevier Science 🌐 English ⚖ 319 KB

High-speed machining of titanium alloys generates high cutting temperature in the cutting zone, which decreases tool life rapidly. So the improvement of the tool life in the high-speed machining of titanium alloys very much depends on the effectiveness of the cooling/lubrication provided. In this pa