๐”– Bobbio Scriptorium
โœฆ   LIBER   โœฆ

Investigation of Grinding Process Simulation

โœ Scribed by Yu, Tian Biao; Zhang, Jing Qiang; Guan, Peng; Wang, Wan Shan

Book ID
127315873
Publisher
Trans Tech Publications, Ltd.
Year
2010
Tongue
English
Weight
635 KB
Volume
126-128
Category
Article
ISSN
1662-8958

No coin nor oath required. For personal study only.

๐Ÿ“œ SIMILAR VOLUMES

Advances in Simulation of Grinding Proce
Advances in Simulation of Grinding Process
โœ Guan, Peng; Li, Ji Qiang; Zhu, Shuang; Yu, Tian Biao; Wang, Wan Shan ๐Ÿ“‚ Article ๐Ÿ“… 2011 ๐Ÿ› Trans Tech Publications Inc. ๐ŸŒ English โš– 537 KB
Grinding process simulation in a ballmil
Grinding process simulation in a ballmill
โœ Stanislaw Tarasiewicz; Peter Radziszewski ๐Ÿ“‚ Article ๐Ÿ“… 1990 ๐Ÿ› Elsevier Science ๐ŸŒ English โš– 222 KB
Analysis and simulation of the grinding
Analysis and simulation of the grinding process. Part II: Mechanics of grinding
โœ Xun Chen; W. Brian Rowe ๐Ÿ“‚ Article ๐Ÿ“… 1996 ๐Ÿ› Elsevier Science ๐ŸŒ English โš– 686 KB

This paper is the second of three parts which describe the analysis and simulation of the grinding process. Generation of the workpiece surface depends on the interactions between the grains of the wheel and the workpiece. The grinding wheel surface generated by dressing was simulated by the method

Computer simulation of the plunge centre
Computer simulation of the plunge centreless grinding process
โœ S.S. Pande; A.R. Naik; S. Somasundaram ๐Ÿ“‚ Article ๐Ÿ“… 1993 ๐Ÿ› Elsevier Science ๐ŸŒ English โš– 487 KB

This paper reports the kinematic analysis of the plunge centreless grinding process considering a uniform mode of infeed. Computer simulation was carried out initially for an ideally round workpiece and regulating wheel, and the optimum set-up and process parameters such as the workpiece surface spe