✦ LIBER ✦

Intelligent optimization and selection of machining parameters in finish turning and facing of Inconel 718

✍ Scribed by J. S. Senthilkumaar; P. Selvarani; R. M. Arunachalam

Publisher: Springer
Year: 2011
Tongue: English
Weight: 299 KB
Volume: 58
Category: Article
ISSN: 0268-3768
DOI: 10.1007/s00170-011-3455-7

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Investigation and optimization of lubric

Investigation and optimization of lubrication parameters in high speed turning of superalloy Inconel 718

✍ Dinesh G. Thakur; B. Ramamoorthy; L. Vijayaraghavan 📂 Article 📅 2010 🏛 Springer 🌐 English ⚖ 234 KB

Effect of tool edge wear on the cutting

Effect of tool edge wear on the cutting forces and vibrations in high-speed finish machining of Inconel 718: an experimental study and wavelet transform analysis

✍ Ning Fang; P. Srinivasa Pai; S. Mosquea 📂 Article 📅 2010 🏛 Springer 🌐 English ⚖ 387 KB

Multi-objective optimization of surface

Multi-objective optimization of surface roughness and cutting forces in high-speed turning of Inconel 718 using Taguchi grey relational analysis (TGRA)

✍ Raju Shrihari Pawade; Suhas S. Joshi 📂 Article 📅 2011 🏛 Springer 🌐 English ⚖ 415 KB

Selection of optimal MQL and cutting con

Selection of optimal MQL and cutting conditions for enhancing machinability in turning of brass

✍ V.N. Gaitonde; S.R. Karnik; J. Paulo Davim 📂 Article 📅 2008 🏛 Elsevier Science 🌐 English ⚖ 322 KB

Minimum quantity of lubrication (MQL) in machining is an established alternative to completely dry or flood lubricating system from the viewpoint of cost, ecology and human health issues. Hence, it is necessary to select proper MQL and cutting conditions in order to enhance machinability for a given