✦ LIBER ✦

Integrated seal design for joint cover assembly

Publisher: Elsevier Science
Year: 2009
Tongue: English
Weight: 248 KB
Volume: 2009
Category: Article
ISSN: 1350-4789
DOI: 10.1016/s1350-4789(09)70337-x

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Seal profile for joints between covering

Seal profile for joints between covering plates

📂 Article 📅 2006 🏛 Elsevier Science 🌐 English ⚖ 227 KB

A new seal wire for glass is described in this patent. It has an outer iron layer instead of copper on the traditional dumet core wire. The weight ratio between iron and alloy in the whole glass seal wire is controlled, so that the expansion coefficient of the composite wire is close to that of the

Sealed joint assembly for two pipe secti

Sealed joint assembly for two pipe sections

📂 Article 📅 2009 🏛 Elsevier Science 🌐 English ⚖ 169 KB

Sealing sub-assembly for a ball joint

📂 Article 📅 2010 🏛 Elsevier Science 🌐 English ⚖ 115 KB

## TRW Automotive GmbH, Germany A seal arrangement for the fitting of a balljoint boot to a steering knuckle is described. An L-section, metal ring forms an interference fit with the shaft. The radial flange has an integral elastomer seal that seals against the flange of the joint. The boot itself

Integrated seal for fuel cell assembly a

Integrated seal for fuel cell assembly and fuel cell

📂 Article 📅 2007 🏛 Elsevier Science 🌐 English ⚖ 104 KB

Sealed cover assembly for an in-floor fi

Sealed cover assembly for an in-floor fitting

📂 Article 📅 2002 🏛 Elsevier Science 🌐 English ⚖ 166 KB

properties against oxygen. It is melt-blended with a liquid polybutene oil plasticizer in an amount insufficient to render the plasticized elastomer tacky. If made tacky, enough 'de-tackifier' is used to allow the product to be formed into a removable seal. The TPE may be a conventional thermoplasti

Automated path planning for integrated a

Automated path planning for integrated assembly design

✍ James H. Oliver; H.-T. Huang 📂 Article 📅 1994 🏛 Elsevier Science 🌐 English ⚖ 943 KB

A technique is described for finding a collision-free path for a free component relative to a reference stationary component or subassembly, to facilitate automated assembly design. Given a part mating sequence and total assembly transformation matrices for each component, a method is presented to d