✦ LIBER ✦

Integral approach for production of thermoplastics microparts by injection moulding

✍ Scribed by Zhiltsova, T. V.; Oliveira, M. S. A.; Ferreira, J. A.

Book ID: 118801274
Publisher: Springer
Year: 2012
Tongue: English
Weight: 556 KB
Volume: 48
Category: Article
ISSN: 0022-2461
DOI: 10.1007/s10853-012-6669-7

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

A New Approach to the Optimization of Bl

A New Approach to the Optimization of Blends Composition in Injection Moulding of Recycled Polymers

✍ G. Lucchetta; P.F. Bariani; W.A. Knight 📂 Article 📅 2006 🏛 International Academy for Production Engineering 🌐 English ⚖ 165 KB

The use of recycled polymers is widespread for the injection moulding of many commodity plastic parts. Recycled polymers are usually blended with virgin polymers to obtain the best trade-off between cost and low melt viscosity. This last constraint is necessary to avoid short shots and to minimize t

Part segmentation by superquadric fittin

Part segmentation by superquadric fitting-a new approach towards automatic design of cooling system for plastic injection mould

✍ C. L. Li 📂 Article 📅 2006 🏛 Springer 🌐 English ⚖ 618 KB

An integrated catalytic approach for the

An integrated catalytic approach for the production of hydrogen by glycerol reforming coupled with water-gas shift

✍ Edward L. Kunkes; Ricardo R. Soares; Dante A. Simonetti; James A. Dumesic 📂 Article 📅 2009 🏛 Elsevier Science 🌐 English ⚖ 344 KB

A deep knowledge of the behaviour of mul

A deep knowledge of the behaviour of multi-component products for stone protection by an integrated analysis approach

✍ Calia, Angela; Colangiuli, Donato; Lettieri, Mariateresa; Matera, Loredana 📂 Article 📅 2013 🏛 Elsevier Science 🌐 English ⚖ 726 KB

Integrity of complex shaped products mad

Integrity of complex shaped products made by powder injection moulding (PIM): K.F. Hens et al, (Rensselaer Polytechnic Institute, New York, USA), Powder Metallurgy International, Vol 23, No 1, 1991, 15–21

📂 Article 📅 1991 🏛 Elsevier Science 🌐 English ⚖ 120 KB

Production of a bimetallic cylinder for

Production of a bimetallic cylinder for plastics injection moulding machine by hot isostatic pressing (HIP): S. Nakamura, et al, (Kobe Steel, Japan), Kobelco Technology Review, No 9, 1990, 24–28

📂 Article 📅 1991 🏛 Elsevier Science 🌐 English ⚖ 129 KB