๐”– Bobbio Scriptorium
โœฆ   LIBER   โœฆ

Influence of the tool clearance in the cylindrical cup-drawing process

โœ Scribed by You-Min Huang; Jia-Wine Chen

Publisher
Elsevier Science
Year
1996
Tongue
English
Weight
737 KB
Volume
57
Category
Article
ISSN
0924-0136

No coin nor oath required. For personal study only.

๐Ÿ“œ SIMILAR VOLUMES

Investigation into the wrinkling behavio
Investigation into the wrinkling behaviour of thin sheets in the cylindrical cup deep drawing process using bifurcation theory
โœ J. B. Kim; J. W. Yoon; D. Y. Yang ๐Ÿ“‚ Article ๐Ÿ“… 2003 ๐Ÿ› John Wiley and Sons ๐ŸŒ English โš– 936 KB

## Abstract The initiation and growth of wrinkles are influenced by many factors such as stress ratios, the mechanical properties of the sheet material, the geometry of the workpiece, and contact condition. It is difficult to analyse wrinkling initiation and growth while considering all the factors

Numerical and failure analysis on the dr
Numerical and failure analysis on the drawing of a circular cylindrical cup
โœ C.K. Chao; C.H. Liu; H.J. Wu ๐Ÿ“‚ Article ๐Ÿ“… 1993 ๐Ÿ› Elsevier Science ๐ŸŒ English โš– 823 KB

The incremental theory of plasticity is applied in conjunction with finite elements for modeling of the circular cylindrical cup. A punch/die system is prescribed such that a circular blank is displaced at constant increments of 0.005 mm until a cup 16 mm deep is formed. Based on the strain energy d

Prediction of the limiting drawing ratio
Prediction of the limiting drawing ratio and the maximum drawing load in cup-drawing
โœ Daw-Kwei Leu ๐Ÿ“‚ Article ๐Ÿ“… 1997 ๐Ÿ› Elsevier Science ๐ŸŒ English โš– 708 KB

Almtract--A new, simple and practically applicable equation, including the normal anisotropy value R and the strain hardening exponent n, for estimating the limiting drawing ratio LDR in cup-drawing of a cylindrical cup with a flat-nosed punch is derived. The normal anisotropy is based on Hill's the