𝔖 Bobbio Scriptorium
✦   LIBER   ✦

Influence of the Injection Molding Process on the Free Volume and Its Effect on the Creep Behavior of Styrene-Acrylonitrile Copolymer

✍ Scribed by K. Engelsing; G. Mennig

Book ID
110282077
Publisher
Springer Netherlands
Year
2001
Tongue
English
Weight
108 KB
Volume
5
Category
Article
ISSN
1385-2000

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

On the synthesis of poly(ε-caprolactam)—
On the synthesis of poly(ε-caprolactam)—poly(butadiene-co-acrylonitrile) block copolymers for the reaction injection molding process
✍ Jaroslav Stehlíček; Frantiček Lednický; Josef Baldrian; Jan Šebenda; Emil Neuhäu 📂 Article 📅 1991 🏛 Society for Plastic Engineers 🌐 English ⚖ 906 KB

## Abstract The liquid rubbers Hycar ATBN and HTBN were used in the preparation of poly(ε‐caprolactam)—poly(butadiene‐co‐acrylonitrile) block copolymers intended for reaction injection molding by the anionic polymerization of ε‐caprolactam. The conversion of Hycar end groups to polymerization growt