✦ LIBER ✦

Influence of semisolid forging ratio on the microstructure and mechanical properties of Ti14 alloy

✍ Scribed by Yong-nan Chen, Gang Liu, Xue-min Zhang…

Book ID: 120669992
Publisher: Springer-Verlag
Year: 2013
Tongue: English
Weight: 567 KB
Volume: 20
Category: Article
ISSN: 1674-4799
DOI: 10.1007/s12613-013-0722-7

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Influence of Ti, B and Sr on the microst

Influence of Ti, B and Sr on the microstructure and mechanical properties of A356 alloy

✍ D. G. Mallapur; S. A. Kori; K. Rajendra Udupa 📂 Article 📅 2010 🏛 Springer 🌐 English ⚖ 566 KB

Microstructure and mechanical properties

Microstructure and mechanical properties of ceramic coatings on Ti and Ti-based alloy

✍ B. Surowska; J. Bieniaś; M. Walczak; K. Sangwal; A. Stoch 📂 Article 📅 2004 🏛 Elsevier Science 🌐 English ⚖ 522 KB

Influence of cooling rate on microstruct

Influence of cooling rate on microstructure and mechanical properties of a Ti–48Al alloy

✍ F. Perdrix; M.F. Trichet; J.L. Bonnentien; M. Cornet; J. Bigot 📂 Article 📅 1999 🏛 Elsevier Science 🌐 English ⚖ 225 KB

Influence of yttrium on microstructure,

Influence of yttrium on microstructure, mechanical properties and deformability of Ti–43Al–9V alloy

✍ Yuyong Chen; Fantao Kong; Jiecai Han; Ziyong Chen; Jing Tian 📂 Article 📅 2005 🏛 Elsevier Science 🌐 English ⚖ 360 KB

Microstructural evolution and mechanical

Microstructural evolution and mechanical properties of the semisolid Al–4Cu–Mg alloy

✍ Jiang Haitao; Lu Yalin; Huang Weichao; Li Xiaoli; Li Miaoquan 📂 Article 📅 2003 🏛 Elsevier Science 🌐 English ⚖ 316 KB

The effect of forging temperature on mic

The effect of forging temperature on microstructure and mechanical properties of in situ TiC/Ti composites

✍ Feng-cang Ma; Wei-jie Lu; Ji-ning Qin; Di Zhang; Bo Ji 📂 Article 📅 2007 🏛 Elsevier Science ⚖ 825 KB

In this paper, 2 vol% TiC/Ti-1100 composites were fabricated using in situ technologies, and the b transus temperature of the composite was measured by metallographic techniques. The ingots after breakdown were forged in various temperature ranges, i.e. in the b phase field, in the (a + b) phase fie