✦ LIBER ✦

Influence of Milling Process Parameters on the Surface Integrity of CFRP

✍ Scribed by Oliver Pecat; Rüdiger Rentsch; Ekkard Brinksmeier

Book ID: 116845722
Publisher: Elsevier
Year: 2012
Tongue: English
Weight: 891 KB
Volume: 1
Category: Article
ISSN: 2212-8271
DOI: 10.1016/j.procir.2012.04.083

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Experimental techniques for studying the

Experimental techniques for studying the effects of milling roller-burnishing parameters on surface integrity

✍ M.M El-Khabeery; M.H El-Axir 📂 Article 📅 2001 🏛 Elsevier Science 🌐 English ⚖ 214 KB

Investigation of micro-milling process p

Investigation of micro-milling process parameters for surface roughness and milling depth

✍ Ibrahim Etem Saklakoglu; Sefika Kasman 📂 Article 📅 2010 🏛 Springer 🌐 English ⚖ 517 KB

An Integrated Telemetric Thermocouple Se

An Integrated Telemetric Thermocouple Sensor for Process Monitoring of CFRP Milling Operations

✍ K. Kerrigan; J. Thil; R. Hewison; G.E. O’Donnell 📂 Article 📅 2012 🏛 Elsevier 🌐 English ⚖ 774 KB

Influence of laser cutting parameters on

Influence of laser cutting parameters on CFRP part quality

✍ A. Goeke; C. Emmelmann 📂 Article 📅 2010 🏛 Elsevier 🌐 English ⚖ 529 KB

Influence of impurities on the milling p

Influence of impurities on the milling process of MgH2

✍ J.R. Ares; K.-F. Aguey-Zinsou; T. Klassen; R. Bormann 📂 Article 📅 2007 🏛 Elsevier Science 🌐 English ⚖ 490 KB

235. The influence of surface treatments

235. The influence of surface treatments on the impact strength of CFRP

✍ E. Fitzer; H. Jäger; R. Weiss 📂 Article 📅 1984 🏛 Elsevier Science 🌐 English ⚖ 130 KB

The impact strength of UDmodel-composites was studied systematically by reinforcement with varied surface treated type I and type II C-fibres. The results show a different behaviour in crack-propagation using high modulus or high tensile C-fibres. This different behaviour is discussed especially wit