In present work, an attempt has been made to investigate the wear behavior of as-cast ZE41A magnesium alloy during dry sliding. The experiments were performed using pin-on-disc type wear apparatus against a EN32 steel counterface in a load range of 30-150 N, sliding velocity range of 0.5-2.5 m/s and
Influence of Microstructure on Corrosion of As-cast ZE41
✍ Scribed by M.-C. Zhao; M. Liu; G. L. Song; A. Atrens
- Publisher
- John Wiley and Sons
- Year
- 2008
- Tongue
- English
- Weight
- 968 KB
- Volume
- 10
- Category
- Article
- ISSN
- 1438-1656
No coin nor oath required. For personal study only.
📜 SIMILAR VOLUMES
Casting experiments were carried out to produce gray cast irons with compositions in the range (wt.%): Fe-3.2C-wCu-xMo-yMn-zSi, where w = 0.78-1.79, x = 0.11-1.17, y = 0.68-2.34 and z = 1.41-2.32. These key elements were varied systematically during sand casting into 30-mm diameter bars to assess th
## Abstract Hyperduplex UNS S32707 is a newly developed austenitic–ferritic stainless steel. The steel contains about 27%Cr, 7%Ni, 4.5%Mo, and 0.4%N, which results in a pitting resistance equivalent factor (PRE) equal to 49. In this study, the pitting corrosion resistance of this new grade of stain
A novel AZ91 Ce containing magnesium alloy characterized by excellent corrosion resistance is fabricated by adding rare earth Ce (cerium) in the form of a Mg-Ce master alloy. The metallographic investigation shows that Ce added to AZ91 can obviously decrease the size of b-Mg 17 Al 12 and forms Al 11
## Abstract Effects of Sn and Ca additions on microstructure, mechanical properties, and corrosion resistance of the as‐cast Mg‐6Zn‐2Al‐based alloy were investigated by SEM, XRD, tensile tests, electrochemical measurements, etc. The higher the Sn content, the higher the yield strength of the Mg‐6Zn